13.3” LOW VOLTAGE BedMate II DTV Operations Manual - Hci
13.3” LOW VOLTAGE BedMate II DTV Operations Manual - Hci
13.3” LOW VOLTAGE BedMate II DTV Operations Manual - Hci
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
----------------------------------------------------------------------------------<strong>BedMate</strong> <strong>II</strong> OPERATIONS MANUAL<br />
PIL<strong>LOW</strong> SPEAKER OPERATION<br />
See page 24 for information on pillow speaker type selection.<br />
See pages 17 and 25 to disable the TV’s internal speakers or turn on pillow speaker sound.<br />
The BM13<strong>II</strong> has a ¼” jack for pillow speaker connection. A one button analog pillow speaker, digital pillow speaker set for<br />
Zenith or Philips code, HCI Visitor station or a Sip and Puff device can be used.<br />
Pin Out<br />
Sip and Puff control is via mechanical switch closure between Tip or Ring and Common.<br />
Starting with the set off and switch closure between Ring and Common will turn the set on. Once set is on a momentary closure<br />
will change the channel one channel. Maintaining the switch closure for about 3 seconds will change direction of the change.<br />
For instance if channel change was up to the next higher channel the direction will change to down and change to the next lower<br />
channel. The change is indicated on the screen. Holding the closure for about 5 seconds will turn the set off. A single button<br />
pillow speaker will also function this way.<br />
A switch closure between Tip and common will cause the volume to change. Maintaining the switch closure for about 3 seconds<br />
will change direction of the change. For instance if volume change was up the direction will change to down. The change is<br />
indicated on the screen. Holding the closure for about 5 seconds will mute the sound. The next closure will un-mute the sound.<br />
A sip and puff device must be a two function device to control volume. Single function devices can only control channel change<br />
and power.<br />
NOTE: When the set is set for Sip and Puff operation audio is not available from the pillow speaker jack.<br />
IR BANDS<br />
SIP and Puff Connections<br />
Tip Volume/Mute<br />
Ring Channel/Power<br />
Sleeve Common<br />
There are four IR bands available. Bands one and two are for HCI IR remote controls. To change the IR band of the HCI IR<br />
remote control press and hold the power button for 10 seconds. Bands 3 and 4 are for universal IR remotes. Band 3 is for<br />
Magnavox codes and band 4 is for Apex codes. You can change IR bands is the setup menu (see page 24) or by pressing the<br />
VOL+ and CH+ buttons on the front panel at the same time.<br />
HealthCare Information, LLC 28
Change language