You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
OUTSIDE MOUNT 135º BAY WINDOW<br />
1. Measure outside each section from the architrave to the back of where frame would<br />
sit as shown above.<br />
2. A+B+C = total window width. This is the width you enter on the order as finish size<br />
3. The total width of A is the location of bay post 1<br />
4. The total width of A + B is the location of bay post 2<br />
5. If a divider rail is required, measure from the floor or outside of architrave to the centre<br />
of the required divider rail location. Remember rails could vary up to 40mm if not<br />
specified critical.<br />
6. If a T post is required, measure from the outside of architrave at left to the centre of the<br />
T post location. T post location in area B would be A + Post position<br />
7. For multiple T posts, measure from outside of architrave at left to the centre of each<br />
following post location. A + post 2 position etc<br />
INSIDE MOUNT 90º CORNER WINDOW<br />
1. Measure inside each section at the front edge of<br />
the reveal as shown left.<br />
2. A+B = total window width.<br />
3. This is the size you enter on the order as window size<br />
4. The total width of A is the location of corner post<br />
5. If a divider rail is required, measure from the inside<br />
bottom to the centre of the required divider rail<br />
location. Remember rails could vary up to 40mm if<br />
not specified critical.<br />
6. If a T post is required, measure from the inside left to<br />
the centre of the T post location<br />
7. T post location in area B would be A + Post position<br />
37