You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
OUTSIDE MOUNT 90º CORNER WINDOW<br />
1. Measure outside from the architrave to the back of<br />
where the frame would sit, at the front edge of the<br />
window as shown left.<br />
2. A+B = total window width.<br />
3. This is the size you enter on the order as finish size<br />
4. The total width of A is the location of corner post<br />
5. If a divider rail is required, measure from the floor or<br />
outside of architrave to the centre of the required<br />
divider rail location. Remember rails could vary up<br />
to 40mm if not specified critical.<br />
6. If a T post is required, measure from the outside of<br />
architrave at left to the centre of the T post<br />
7. T post location in area B would be A + Post position<br />
INSIDE MOUNT TRACK BIFOLDS<br />
Headboards are supplied as standard for track bifolds with top track attached. Sideboards and<br />
bottom boards are optional however floor track is mandatory with no option to waive warranty.<br />
Track bifolds can be installed inside mount and standard deductions are taken at the factory to<br />
allow for fitting. If semi recess mount is required with shorter returns, you must specify this in notes.<br />
Ensure there is enough clearance for doorhandles, track layouts are specified on the next page.<br />
1. Measure the recess depth<br />
2. Measure the diagonal to check for squareness.<br />
If the diagonal sizes vary by more than 10mm, an outside mount is preferable<br />
3. Measure inside width in at least 3 places (top, centre and bottom)<br />
4. Provide the smallest width size as window size, do NOT take a deduction<br />
5. Measure inside height in at least 3 places (left, centre and right)<br />
6. Provide the smallest height size as window size, do NOT take a deduction<br />
7. If a divider rail is required, measure from the inside bottom to the centre of the required<br />
divider rail location. Remember rails could vary up to 40mm if not specified critical.<br />
OUTSIDE MOUNT TRACK BIFOLDS<br />
Headboards are supplied as standard for track bifolds with top track attached. Sideboards and<br />
bottom boards are optional however sideboards are recommended for outside mount to<br />
provide better light block. It is common practice to mount headboard and sideboards outside<br />
of the architrave hard up against the wall. For this layout, you will need to add extra to your sizes<br />
to allow for boards. Ensure there is enough clearance for doorhandles. Track layouts are specified<br />
on the next page.<br />
1. Measure outside of architrave width in at least 3 places (top, centre and bottom)<br />
2. Add at least 38mm for sideboards (if required) as finish size<br />
3. Measure outside of architrave height in at least 3 places (left, centre and right)<br />
4. Add at least 19mm for headboard as finish size<br />
5. If a divider rail is required, measure from the floor or outside of architrave to the centre<br />
of the required divider rail location. Remember rails could vary up to 40mm if not<br />
specified critical.<br />
38