magicolor 3730DN User's Guide - Konica Minolta
magicolor 3730DN User's Guide - Konica Minolta
magicolor 3730DN User's Guide - Konica Minolta
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7-40<br />
This message... means... do this...<br />
MEDIA JAM<br />
FUSER<br />
X TONER<br />
NOT INSTALLED<br />
PUT MEDIA: TRAY X<br />
“SIZE”<br />
“TYPE”<br />
Service Messages<br />
Media has misfed<br />
leaving the fuser<br />
area.<br />
The enclosed toner<br />
cartridges are not<br />
installed.<br />
The X toner cartridge<br />
is not installed, or an<br />
unapproved toner<br />
cartridge is installed.<br />
The X (Tray 1 or 2)<br />
was specified with the<br />
printer driver for printing,<br />
but Tray X is<br />
empty.<br />
WASTE BOTTLE FULL The waste toner<br />
bottle is full.<br />
Refer to “Media Misfeed<br />
Messages and Clearing<br />
Procedures” on<br />
page 7-6, and remove<br />
the misfed media.<br />
Be sure to install the<br />
enclosed toner cartridges.<br />
Install a correct KONICA<br />
MINOLTA toner cartridge.<br />
Load the correct media<br />
into the specified tray.<br />
Install a new waste toner<br />
bottle.<br />
These messages indicate a more serious error that can only be corrected by<br />
a customer service engineer. If one of these messages appears, turn the<br />
printer off, then turn it on again. If the problem persists, contact your local<br />
vendor or authorized service provider.<br />
This service<br />
message...<br />
FATAL ERROR CODE:<br />
XXXX<br />
means... do this...<br />
An error has been<br />
detected with the item<br />
indicated “XXXX” in the<br />
service message.<br />
Information about errors<br />
appears at the bottom of<br />
the message window.<br />
Reboot the printer. This<br />
often clears the service<br />
message, and printer<br />
operation can resume.<br />
If the problem persists,<br />
contact Technical Support.<br />
Status, Error, and Service Messages