SERVICE MANUAL MR-G57N-T-NZ - B.d.t.
SERVICE MANUAL MR-G57N-T-NZ - B.d.t.
SERVICE MANUAL MR-G57N-T-NZ - B.d.t.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Door adjustment<br />
<br />
• Common elements<br />
First, check the installation condition.<br />
If the adjustment bolt is not in contact with the floor, lower the bolt, and adjust it so that the caster is slightly above the floor.<br />
When the refrigerator is installed in the corner of the room, the bolt of the refrigerator may sink into the floor and cause the refrigerator<br />
to tilt. It is recommended to make adjustments by objects like boards beforehand.<br />
When the refrigerator bolt is sunk into the floor, and it can be confirmed visually, prevent sinking by using objects like boards.<br />
Note : The refrigerator weighs about 100kg, and is held by four bolts. How far each bolt sinks into the floor depends on<br />
factors such as floor pillars. Change in balance due to position of stored food (such as large or small amount of food<br />
stored in the door pockets) may also affect sinking.<br />
<br />
Problem<br />
Solution<br />
Adjusting doors horizontally<br />
A<br />
B<br />
A>B (More space in outer side)<br />
Or<br />
AB (Too much space between the ice<br />
making compartment and versa compartment<br />
doors.)<br />
Misaligned versa compartment door<br />
Misaligned ice making<br />
compartment door<br />
Replace roller set of the right<br />
and left versa compartment<br />
doors.<br />
a To adjust about 0.5mm<br />
replace with roller set C.<br />
b To make large adjustment<br />
replace with roller set D.<br />
Replace lower roller set of the<br />
ice making compartment door.<br />
c To adjust about 0.5mm<br />
replace with roller set A.<br />
d To make large adjustment<br />
replace with roller set B.<br />
B<br />
A<br />
Marking<br />
right 0.5 [10]<br />
right 1.0 [12]<br />
left 0.5 [14]<br />
left 1.0 [16]<br />
A