Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Quickstart!<br />
Even though you might be eager to use your<br />
newly purchased <strong>Pedelec</strong> immediately, we<br />
request you to observe the following steps<br />
without fail before taking your first ride. we will<br />
not acceptany guarantee obligations otherwise!<br />
The <strong>ED</strong>-<strong>1.2</strong> <strong>Pedelec</strong> is powered by a<br />
lithium-ion battery. A new <strong>ED</strong>-<strong>1.2</strong> <strong>Pedelec</strong><br />
battery comes in „ship-mode“. Batteryinternal<br />
electronics is almost fully shut<br />
down and no voltage is available. To<br />
activate the battery please keep it in<br />
the carrier bay and connect the charger.<br />
Approx. 30 sec. later the battery is fully<br />
switched on. Please check current<br />
charging status by pressing the key on<br />
battery L<strong>ED</strong> display.<br />
• Now charge the battery fully first! Please use<br />
the original Lithium-ion charging device only.<br />
• Adjust the handle bar and seat; check to<br />
ensure that the drive and brakes function<br />
and that all screws, especially the wheel nuts<br />
are properly fixed (refer to Page 34).<br />
• Start pedalling. The motor is activated after a<br />
half-rotation of the pedals.<br />
• If you are riding this bicycle for the first time,<br />
please try out the available operation modes<br />
in low-traffic areas.<br />
• Of the available operation modes 1 to 3<br />
restrict the max power level. This facilitates<br />
an increase in operating distance.<br />
• At the end of the ride, shut off the system by<br />
pressing the “ON/OFF“ button.<br />
• The <strong>Pedelec</strong> will take you home even on<br />
an empty battery like an ordinary cycle. The<br />
battery electronics prevents an excessive<br />
discharge of the battery.<br />
• Recharge the fully empty Lithium-ion battery<br />
after completing the ride.<br />
• If you do not use the battery for more than 3<br />
month, recharge it fully.<br />
Enjoy riding your <strong>Pedelec</strong>!<br />
• Switch the system on at the left of the handle<br />
bar: Press the switch to “I” on the control<br />
unit. The <strong>Pedelec</strong> is now ready for a ride. The<br />
electronic circuit however is deactivated after<br />
approx. 8 min of inactivity in order to save<br />
energy! If this happens, switch off and then<br />
on again.<br />
24