Manuale Operatore Operator's Manual Manuel d'utilisation ...

EMBEDDED
WATER SOFTENER
FILL THE
DETERGENT
10
Mount the supplied ring nut and the pipe-union on the threaded connector and seal with
the washer.
Use the supplied draining pipe to connect both pipe-unions (side equipment and central
drain); tight with clamps.
Central drain
connector
Water
outlet
Pipe-union and ring nut
(supplied)
Clamp
Washer
Clamp
Power
cord
Drain pipe
(supplied)
The embedded water softener is made up of resin filters that reduce the salinity of the
water supplying the machine.
In case of particularly hard water, the unit deteriorates quickly affecting its performance
and life.
In order to keep active, it is necessary to periodically regenerated the resins, especially
when the display shows the message “SALT LOAD” or “CLN” (see Appendix C
“Maintenance”)
In the units equipped with this device, the installer should program, according to the water
hardness, a special parameter for showing the regeneration message as necessary.
The compartment under the door includes a 450 cc container for the liquid detergent and a
pump to dose the detergent ; the dose value is programmable and preset according to the
data from the detergent manufacturer (average consumption about 10 cc. per cycle).
WARNING
TO ENSURE THE CORRECT OPERATION OF THE PUMPS, HAVE THE
GENERAL MAINTENANCE CARRIED OUT AS PER THE SCHEDULE
INCLUDED IN APPENDIX C.
Open the door of the lower compartment and fill the container with the supplied detergent.
NOTE
IT IS RECOMMENDED TO USE THE DETERGENT “MEDICLEAN” BY THE
DR.WEIGHERT COMPANY.
SEE APPENDIX A” – TECHNICAL CHARACTERISTICS.
FOR MORE DETAILS CALL THE CUSTOMER SUPPORT OR THE RESELLER.
The units includes a sensor for the detergent has run out. This condition is signaled with
the message “NO DETERGENT” on the display. For further details see Appendix “E”.
NOTE
THE UNIT CARRIES OUT THE CYCLE ALSO WITHOUT DETERGENT AND ADDITIVES.