Manuale Operatore Operator's Manual Manuel d'utilisation ...
Manuale Operatore Operator's Manual Manuel d'utilisation ...
Manuale Operatore Operator's Manual Manuel d'utilisation ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
IN CASE OF<br />
BLACK-OUT<br />
DOOR<br />
UNBLOCKING<br />
PROCEDURE<br />
RESINS<br />
REGENERATION<br />
Upon the mains restore after a black-out, the unit will signal the event by showing on the<br />
display the message “POWER FAIL” and store the washing program position before the<br />
black-out.<br />
At the mains restore, the unit can enter in Standby or Block status. From this condition it is<br />
possible:<br />
• enter a START command to resume the cycle;<br />
• carry out the unblocking procedure and repeat the cycle.<br />
In “Block” status, the door remains blocked; to unblock the door it is necessary to perform<br />
the following procedure:<br />
1. Press together START and STOP keys for 5 seconds<br />
+ .<br />
2. Press the program selection keys in sequence<br />
2 1 .<br />
The unit enters in “Standby”.<br />
NOTE<br />
IF THE FAULT CONDITION PERSISTS FOR A MALFUNCTION, THE DOOR IS UNBLOCKED<br />
BUT THE UNIT STILL DOES NOT WORK.<br />
IN THIS SITUATION CALL THE CUSTOMER SUPPORT.<br />
When the unit detects a value of water hardness over the threshold (degradation of the<br />
water softening function), the message “SALT LOAD” or “CLN” is shown on the display.<br />
In this case it is necessary to carry out the regeneration procedure. See Appendix “C” -<br />
Maintenance.<br />
13<br />
ENGLISH