capaNCDT 6100 - Micro-Epsilon

Installation and Assembly4.Installation and Assembly4.1Precautionary MeasuresNo sharp-edged or heavy objects may come into contact with the sensor cable sheath.Protect the cable in pressurised rooms against pressure loads.The minimum bending radius is 10 mm (.39 inch). Avoid kinks at all cost.iCheck the connections for tight fit.A damaged cable cannot be repaired.4.2 SensorThe sensors of the capaNCDT 6100 may be mounted free-standing or flush.When assembling, make sure that the polished sensor surface is not scratched.4.2.1 Sensor Radial Point Clamping with Grub ScrewThis simple type of fixture is only recommended for a force and vibration-free installation position. The grubscrew must be made of plastic so that it cannot damage or deform the sensor housing.Grub screwFig. 3 Radial point clamping with grub screwDo not use metal grub screws!>>Danger of damaging the sensorcapaNCDT 6100Page 42