capaNCDT 6100 - Micro-Epsilon

Installation and Assembly4.5 Power Supply and Signal OutputThe power supply and signal output are connected by the 8-pin built-in connector (DlN 45326). Pin assignment,see Fig. 5. The controller contains a 8-pin cable socket for the user-side assembly of your own connectingcable.PIN1Assignment0 Volt (24 V operation)6 72 +15 Volt (Option)1833 Output A displacement signal/voltage44 -15 V (Option)255 0 Volt (±15 V operation)6 +24 Volt (24 V operation) Solder pin side7 0 Volt (analog output)cable socket8 Output B signal option (e.g. current)Fig. 5 Pin assignmentIn addition the following applies:Use a double screened cable!-- Outer screening mesh surrounds all cable wires.-- Inner screening mesh surrounds signal wires PIN 3, 7, 8.-- Inner screening mesh at pin 7.-- Total screen via connector housing to housing ground2--Recommended conductor cross-section 0.14 mm (AWG 26)The EMC regulations, see Chap. 1.3, are only satisfied under these basic conditions.iRequirements ofpowerand outputcables to satisfythe EMC regulations.EnglishcapaNCDT 6100Page 51