Installation and start-up - Stange Energietechnik GmbH
Installation and start-up - Stange Energietechnik GmbH
Installation and start-up - Stange Energietechnik GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.2 Environment<br />
Camino Generator<br />
1. The place of installation for the SET-CAMINO Generator shall provide sufficient<br />
space so that all maintenance points are readily accessible.<br />
2. The ambient temperature at the place of installation or in the room should not<br />
exceed 20 °C.<br />
3. Higher ambient temperature will reduce the output of the Diesel engine. If the<br />
room temperature exceeds 20 °C, provide for a separate combustion air s<strong>up</strong>ply.<br />
The soundproofing hood of the SET-CAMINO Generator is provided with a<br />
socket where the combustion air must be s<strong>up</strong>plied via the external air filter.<br />
4. At a length of approx. 3 m of the s<strong>up</strong>ply line, a diameter 40 mm venting hose<br />
can be used.<br />
Insulation<br />
The venting hose shall be mechanically resistant <strong>and</strong> installed without<br />
bends, if possible.<br />
The SET-CAMINO Generator is installed in a soundproofing hood <strong>and</strong> does not require<br />
any additional insulation at the place of installation.<br />
When positioning the generator make sure that maintenance work<br />
<strong>and</strong> checks can be carried out without hindrance.<br />
Please test the following after positioning:<br />
− Air filter replacement<br />
− Fuel filter replacement<br />
− Oil filter replacement<br />
− Vee belt replacement<br />
− Coolant bleeding<br />
− Fuse replacement<br />
− Oil check<br />
03-04-01 <strong>Installation</strong> of the SET Camino Generator 5-32