Operating Instructions - VEGAPULS 54K enamel

Electrical connection
VEGAPULS 54K Ex (loop powered) with pressure-tight encapsulated
connection compartment on active PLC
Two-wire technology, supply via the cable from active PLC to Exd connection housing for
operation in Ex-Zone 1 (VEGAPULS …K Ex) or Ex-Zone 0 (VEGAPULS …K Ex0).
Output signal 4 … 20 mA (passive).
Measured value display integrated in the sensor.
Optional external indicating instrument with analogue and digital display (can be mounted
up to 25 m away from the sensor in Ex area).
Adjustment with PC, HART ® handheld or adjustment module MINICOM (can be plugged into
the sensor or into the external indicating instrument VEGADIS 50).
VEGADIS 50 Ex
Ex area Non Ex area
EEx d ia EEx e
4 2
1)
2
4 … 20 mA
1) If the resistance of the processing systems
connected to the 4 … 20 mA signal output is less
than 200 Ω, a resistor must be connected to the
connection cable during adjustment to get a loop
resistance between 250 Ω up to 300 Ω.
The digital adjustment signal would otherwise be
severely damped or short-circuited due to
insufficient resistance of the connected processing
system. Digital communication with the PC or
the HART ® handheld would not be ensured.
2
2
VEGA-
CONNECT 2
passive 2)
HART ®
handheld
PLC (active)
2) 4 … 20 mA passive means that the sensor
consumes a level-dependent current of
4 … 20 mA. The sensor reacts electrically like a
varying resistor (consumer) to the PLC.
26 VEGAPULS 54K enamel
24 101-EN-041227