Transmission and Differential.pdf - Ken Gilbert
Transmission and Differential.pdf - Ken Gilbert
Transmission and Differential.pdf - Ken Gilbert
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3-4 [W3B0] SERVICE PROCEDURE<br />
3. Rear <strong>Differential</strong> (T-Type)<br />
10) Remove propeller shaft.<br />
CAUTION:<br />
When removing propeller shaft, pay attention<br />
not to damage the sliding surfaces of rear drive<br />
shaft (extension) spline, oil seal <strong>and</strong> sleeve<br />
yoke.<br />
NOTE:<br />
Prepare an oil can <strong>and</strong> cap since the transmission<br />
oil flows out from the extension at removing<br />
propeller shaft.<br />
Insert the cap into the extension to prevent<br />
transmission oil from flowing out immediately after<br />
removing the propeller shaft.<br />
If extension cap is not available, cover the opening<br />
with a vinyl bag in order to prevent transmission<br />
gear oil or ATF leakage.<br />
S3M0033A<br />
11) Remove heat sealed cover.<br />
12) Remove clamps <strong>and</strong> bracket of parking brake<br />
cable.<br />
G3M0053<br />
38<br />
13) Remove DOJ of rear drive shaft from rear differential<br />
using ST. <br />
ST 28099PA100 DRIVE SHAFT REMOVER<br />
G3M1020<br />
14) Secure rear drive shaft to rear crossmember<br />
using wire.<br />
15) Remove lower differential bracket.<br />
G3M1022<br />
H3M1273A<br />
16) Support rear differential with transmission<br />
jack.<br />
G3M0055
Change language