CAD user manual - Finn-Power International, Inc.
CAD user manual - Finn-Power International, Inc.
CAD user manual - Finn-Power International, Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TANGENT- Used to draw geometry tangent to an arc or circle from the<br />
starting point. NOTE- cannot be used as the starting point of a <strong>CAD</strong><br />
function.<br />
HOW TO USE- Start by drawing a circle anywhere within the<br />
drawing window. Draw a line segment select the ‘First Point’<br />
using any type of Snap Mode (not Tangent) and then select<br />
Tangent as the ‘Second Point’ and then click on which side of<br />
the circle or arc the line will be attached to.<br />
SHORTCUT KEY: T<br />
MIDDLE- Uses the middle of a segment as the snap point if selected.<br />
Determines the length or diameter of the selected line segment and finds<br />
the exact middle to be used as ‘Point’.<br />
HOW TO USE- Draw a line and select Middle as the Snap<br />
Mode, use with either ‘First Point’ or ‘Second Point’, and select<br />
anywhere on the desired segment to apply to the middle point.<br />
SHORTCUT KEY: M<br />
HORIZONTAL- ‘Second Point’ of a line being drawn. Allows a line<br />
to be drawn horizontal to attach to a chosen segment (arc or line). When<br />
Horizontal is chosen as the ‘Second Point’ Snap Mode all that is needed<br />
is to click on the chosen segment (arc or line), no need to choose an<br />
additional Snap Mode.<br />
HOW TO USE- when applying a line (either Line 2 Points or<br />
Line to Point) where the starting point is somewhere where it<br />
will intersect through another segment. After choosing the ‘First<br />
Point’ select Horizontal and then click on the intersecting<br />
segment. Line will be drawn ending at that point at 0/180°.<br />
SHORTCUT KEY: H<br />
VERTICAL- ‘Second Point’ of a line being drawn. Allows a line to be<br />
drawn vertical to attach to a chosen segment (arc or line). When<br />
Vertical is chosen as the ‘Second Point’ Snap Mode all that is needed is<br />
to click on the chosen segment (arc or line), no need to choose an<br />
additional Snap Mode.<br />
HOW TO USE- when applying a line (either Line 2 Points or<br />
Line to Point) where the starting point is somewhere where it<br />
will intersect through another segment. After choosing the ‘First<br />
21