CAD user manual - Finn-Power International, Inc.

More documents

Recommendations

Info

Zoom to view the entire part and then click on left side toolbar to delete the construction lines. The newly created obround is within this drawing a total of six times which means that it will need to be copied instead of redrawn. The next step is to copy the obround. STEP 30: Highlight the obround along with the four circles (make sure Allow Selection is activated) STEP 31: Choose Copy STEP 32: Choose Single Copy STEP 33: Choose Current (U) Snap point STEP 34: Choose Relative (R) Snap point Enter the following values: Click OK Select the copied obround and circles and repeat steps 30-34 to add the third obround. Once you have three obrounds on the part these three obrounds will need to be copied again. Select all three obrounds and circles and repeat steps 30-34, but instead of using the Relative Coordinates above use the value displayed below: Click OK The part should now look similar as the picture on the next page. 38
There are two operations left to apply a corner notch and trim to apply a chamfer to a vertex. Corner Notch STEP 35: Choose Notches STEP 36: Choose Corner Notch STEP 37: Starting with the external top left corner of the part click on the vertical line (left side) and then horizontal line (top side). A dialog will now ask for Distance 1 and Distance 2, enter the values from below: Click OK Repeat for all four corner of the part external shape. Chamfer Trim STEP 38: Choose Trims STEP 39: Choose Chamfer STEP 40: Starting with the top left corner of the part select vertical line and horizontal line that create the vertex and enter the values displayed on the next page. 39
Page 1 and 2: Finn-Power International 710 Reming
Page 3 and 4: INTRODUCTION ______________________
Page 5 and 6: 1 GETTING AROUND It is obvious the
Page 7 and 8: Delete Construction Lines Construct
Page 9 and 10: 2 CAD FUNCTIONS As described earlie
Page 11 and 12: Arc Point Radius Subangle- Arc Spec
Page 13 and 14: Rectangular Notch- Input width and
Page 15 and 16: 2.8 Copy When using the Copy functi
Page 17 and 18: 2.10 Modify Commands Undo- Undo the
Page 19 and 20: HOW TO USE- Select Line 2 Point, fo
Page 21 and 22: TANGENT- Used to draw geometry tang
Page 23 and 24: 270°) throughout the circular shap
Page 25 and 26: part. Although there are many diffe
Page 27 and 28: STEP 6: Chose Absolute again from t
Page 29 and 30: Now create a second rectangle in th
Page 31 and 32: 4.2 Exercise 2 We will start with t
Page 33 and 34: The next steps will add two rectang
Page 35 and 36: The next steps will add obround slo
Page 37: on the toolbar to allow selection o
Page 41 and 42: 4.3 Exercise 3 For this part the 0,
Page 43 and 44: STEP 13: Choose End Point from the
Page 45 and 46: STEP 25: NC Express will now ask fo
Page 47 and 48: This means that we can draw more th
Page 49: 5 Appendix Below is a shortcut key

CAD user manual - Finn-Power International, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?