CAD user manual - Finn-Power International, Inc.

The next steps will add obround slots within the internal contour of the part.
Obrounds will be added utilizing both the rectangle and arc functions. NOTE-
After the first obround is added four (4) circles will be added outside each
corner of the obround (rectangle). [Obround size is X: 50mm by Y: 20mm]
STEP 18: Choose Rectangles
STEP 19: Choose Centre, W, H
STEP 20: Choose Indirect Snap point
Within the Evaluator enter the following equation for X: 108+32
Enter the following value for Y: 47.5
Click OK
Click the bottom left corner of the part as the ‘Point’
STEP 21: Once the Indirect point has been chosen a dialog will appear asking
for Width and Height, enter the values shown below:
Click OK
The next step is to add arcs on each end of the rectangle to create the obround.
35