CAD user manual - Finn-Power International, Inc.
CAD user manual - Finn-Power International, Inc.
CAD user manual - Finn-Power International, Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INTRODUCTION _________________________________________________ 4<br />
1 GETTING AROUND ___________________________________________ 5<br />
1.1 Allow Selection _______________________________________________________________ 5<br />
1.1.1 Selecting Elements for Using Copy/Move Functions_________________________________ 5<br />
1.2 Lock Geometry _______________________________________________________________ 6<br />
1.3 Use ESC Key to Exit ___________________________________________________________ 6<br />
1.4 Selecting a <strong>CAD</strong> Function (Toolbars) _____________________________________________ 6<br />
1.5 Additional Features____________________________________________________________ 7<br />
1.6 Evaluator ____________________________________________________________________ 7<br />
2 <strong>CAD</strong> FUNCTIONS ____________________________________________ 9<br />
2.1 Lines ________________________________________________________________________ 9<br />
2.2 Arcs________________________________________________________________________ 10<br />
2.3 Circles______________________________________________________________________ 11<br />
2.4 Rectangles __________________________________________________________________ 12<br />
2.5 Notches _____________________________________________________________________ 12<br />
2.6 Trims ______________________________________________________________________ 13<br />
2.7 Move_______________________________________________________________________ 14<br />
2.8 Copy _______________________________________________________________________ 15<br />
2.9 Measurement ________________________________________________________________ 16<br />
2.10 Modify Commands ___________________________________________________________ 17<br />
3 SNAP MODES ______________________________________________ 18<br />
3.1 Snap Modes Described ________________________________________________________ 18<br />
3.2 Using Construction Lines (Construct)____________________________________________ 24<br />
3.3 Close <strong>CAD</strong> Functions (Hide) ___________________________________________________ 25<br />
4 <strong>CAD</strong> EXERCISES____________________________________________ 26<br />
4.1 Exercise 1 ___________________________________________________________________ 26<br />
4.2 Exercise 2 ___________________________________________________________________ 31<br />
4.3 Exercise 3 ___________________________________________________________________ 41<br />
5 APPENDIX- SHORTCUT KEY/PART PRINTOUTS__________________ 49<br />
3