CAD user manual - Finn-Power International, Inc.

More documents

Recommendations

Info

STEP 7: Choose Line STEP 8: Choose Parallel Element - Distance STEP 9: NC Express asks to touch the element on correct side. (See bottom right corner of NC Express screen, shown below) This means that if we want to create a parallel line on the upside of the line we need to click above the line. If we want to create a parallel line underneath the line we need to click under the line. STEP 10: Click on the upside of the line and the evaluator will appear asking for a distance. Enter a distance of 5mm. The next steps we will create the construction line using two points, keep the option construct active. STEP 11: Choose Line STEP 12: Choose Line 2 Points 42
STEP 13: Choose End Point from the Snap Menu (or type E on the keyboard) and then click on one of the end points of the line. STEP 14: Choose Perp (Perpendicular) from the Snap Menu (or type P on the keyboard) and click on the parallel construct line. Now we have a construction line in one end point of the line: Repeat step 10 until step 13 for the opposite end point of the line. Now we will create a construct line that is the width of our part. STEP 15: Choose Line STEP 16: Choose Parallel Element - Distance STEP 17: NC Express asks to touch the element on correct side, click on the lower side of the horizontal line this time. The evaluator will appear on the screen asking for a distance, enter the value 19.45 (width of the part). Created construct line at 19.45 43
Page 1 and 2: Finn-Power International 710 Reming
Page 3 and 4: INTRODUCTION ______________________
Page 5 and 6: 1 GETTING AROUND It is obvious the
Page 7 and 8: Delete Construction Lines Construct
Page 9 and 10: 2 CAD FUNCTIONS As described earlie
Page 11 and 12: Arc Point Radius Subangle- Arc Spec
Page 13 and 14: Rectangular Notch- Input width and
Page 15 and 16: 2.8 Copy When using the Copy functi
Page 17 and 18: 2.10 Modify Commands Undo- Undo the
Page 19 and 20: HOW TO USE- Select Line 2 Point, fo
Page 21 and 22: TANGENT- Used to draw geometry tang
Page 23 and 24: 270°) throughout the circular shap
Page 25 and 26: part. Although there are many diffe
Page 27 and 28: STEP 6: Chose Absolute again from t
Page 29 and 30: Now create a second rectangle in th
Page 31 and 32: 4.2 Exercise 2 We will start with t
Page 33 and 34: The next steps will add two rectang
Page 35 and 36: The next steps will add obround slo
Page 37 and 38: on the toolbar to allow selection o
Page 39 and 40: There are two operations left to ap
Page 41: 4.3 Exercise 3 For this part the 0,
Page 45 and 46: STEP 25: NC Express will now ask fo
Page 47 and 48: This means that we can draw more th
Page 49: 5 Appendix Below is a shortcut key

CAD user manual - Finn-Power International, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?