CAD user manual - Finn-Power International, Inc.

Now create a second rectangle in the same way as the first (steps 8-10). The
Only differences are that the Height and Centre Y (for absolute) will change.
For Absolute Y use the equation: 53 + 104/2.
For the Height of the rectangle use 104.
Your drawing should now look the same as below:
(Press Escape)
For the final steps of the exercise the rectangles will be copied around the inside
of the circle using the Polar Copy function.
STEP 16: Set Allow Selection on by clicking the button on the toolbar.
STEP 17: Select both of the rectangles within the part, only the rectangle
geometry.
STEP 18: Choose Copy
STEP 19: Choose Polar Copy
STEP 20: Chose Centre from Snap Menu (or type C on the keyboard) and then
click on the circle.
29