CAD user manual - Finn-Power International, Inc.

More documents

Recommendations

Info

STEP 43: Choose Delete Construction Lines We only need to create the corners on the three sides of the part: STEP 44: Choose Trims STEP 45: Choose Fillet STEP 46: Start trim in the far left corner. Choose the First Element (arc) and then the Second Element (top horizontal line). The Evaluator will appear asking for the radius; enter the value 0.5mm for the radius. Repeat step 44 until 46 for the two other corners. Part should look similar to above, save as <strong>CAD</strong>_Drawing3.cp. 48
5 Appendix Below is a shortcut key quick reference that can be printed out and placed on the top edge of the keyboard. Print this page and cutout. The next three pages display a printout of the parts from the three exercises. 49
Page 1 and 2: Finn-Power International 710 Reming
Page 3 and 4: INTRODUCTION ______________________
Page 5 and 6: 1 GETTING AROUND It is obvious the
Page 7 and 8: Delete Construction Lines Construct
Page 9 and 10: 2 CAD FUNCTIONS As described earlie
Page 11 and 12: Arc Point Radius Subangle- Arc Spec
Page 13 and 14: Rectangular Notch- Input width and
Page 15 and 16: 2.8 Copy When using the Copy functi
Page 17 and 18: 2.10 Modify Commands Undo- Undo the
Page 19 and 20: HOW TO USE- Select Line 2 Point, fo
Page 21 and 22: TANGENT- Used to draw geometry tang
Page 23 and 24: 270°) throughout the circular shap
Page 25 and 26: part. Although there are many diffe
Page 27 and 28: STEP 6: Chose Absolute again from t
Page 29 and 30: Now create a second rectangle in th
Page 31 and 32: 4.2 Exercise 2 We will start with t
Page 33 and 34: The next steps will add two rectang
Page 35 and 36: The next steps will add obround slo
Page 37 and 38: on the toolbar to allow selection o
Page 39 and 40: There are two operations left to ap
Page 41 and 42: 4.3 Exercise 3 For this part the 0,
Page 43 and 44: STEP 13: Choose End Point from the
Page 45 and 46: STEP 25: NC Express will now ask fo
Page 47: This means that we can draw more th

CAD user manual - Finn-Power International, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?