CAD user manual - Finn-Power International, Inc.

This means that we can draw more then one solution. Press on the arrow to get
the correct solution. Click OK when the correct solution is found. The correct
solution is when the arc of the circle is touching the outside (lower left) of the
construction circles.
Now we need to complete the drawing using real lines instead of the
construction lines.
STEP 37: Choose Line
STEP 38: Choose Line 2 Points
STEP 39: Choose the First Element- intersection on
the circle on the right side of the part and then choose
the Second element- intersection on the bottom circle
of the part. NOTE- Select Intersection as the Snap
Mode and then click on the circle and then line, you
should not have to zoom in on each end point of the
line.
To create the bottom line of the part the intersection of the arc with the circles
will be chosen:
STEP 40: Choose Arc
STEP 41: Choose Arc 2 Points and Radius
STEP 42: Choose the First Element- construction circle in the left corner of the
part and then choose the Second Element- construction circle on the bottom
corner of the part. Enter 170 as the radius and click OK.
Again we don’t get the required arc but on top of the screen we have the
window that implicates that we have more then one solution. Just click on the
arrow until we have the right arc.
Now we can delete all construction lines.
47