CAD user manual - Finn-Power International, Inc.

More documents

Recommendations

Info

Now we need to create two construction circles at the end points of the line with a radius of 0.5. Leave Construct activated. STEP 18: Choose Circles STEP 19: Choose Circle Tangent 2 Elements STEP 20: NC Express asks to choose First Element, choose the construction line on the left side of the part, and then choose the Second Element, the horizontal line. The evaluator appears on the screen asking for the radius; enter the value for the radius 0.5. Repeat step 18 until 20 on the right side of the line. When we look at the right side of the part we can see that we have line under an angle of 20°. To make this line we will first draw the intersection point with the circle on the right side of the part. STEP 21: Choose Line STEP 22: Choose Line 2 Points STEP 23: Choose Centre from the Snap Menu (or type C on the keyboard) and then click on the circle that is on the right side of the line. STEP 24: Choose Angle from the Snap Menu (or type G on the keyboard) and enter the value -20 within the Evaluator. 44
STEP 25: NC Express will now ask for the Second Element, select the construction line that is drawn vertical at the right end point of the horizontal line. Now we need to create a line from out of this intersection point. STEP 26: Choose Line STEP 27: Choose Line 2 Points STEP 28: Choose the First Element- the intersection point shown to the right. Click directly on the intersection or use Intersection Snap Mode. STEP 29: Choose Angle from the Snap Menu (or type G on the keyboard) and enter the value 70 within the Evaluator. STEP 30: Choose the Second Element- the lower horizontal construction line. Intersection point for the line at 20° 45
Page 1 and 2: Finn-Power International 710 Reming
Page 3 and 4: INTRODUCTION ______________________
Page 5 and 6: 1 GETTING AROUND It is obvious the
Page 7 and 8: Delete Construction Lines Construct
Page 9 and 10: 2 CAD FUNCTIONS As described earlie
Page 11 and 12: Arc Point Radius Subangle- Arc Spec
Page 13 and 14: Rectangular Notch- Input width and
Page 15 and 16: 2.8 Copy When using the Copy functi
Page 17 and 18: 2.10 Modify Commands Undo- Undo the
Page 19 and 20: HOW TO USE- Select Line 2 Point, fo
Page 21 and 22: TANGENT- Used to draw geometry tang
Page 23 and 24: 270°) throughout the circular shap
Page 25 and 26: part. Although there are many diffe
Page 27 and 28: STEP 6: Chose Absolute again from t
Page 29 and 30: Now create a second rectangle in th
Page 31 and 32: 4.2 Exercise 2 We will start with t
Page 33 and 34: The next steps will add two rectang
Page 35 and 36: The next steps will add obround slo
Page 37 and 38: on the toolbar to allow selection o
Page 39 and 40: There are two operations left to ap
Page 41 and 42: 4.3 Exercise 3 For this part the 0,
Page 43: STEP 13: Choose End Point from the
Page 47 and 48: This means that we can draw more th
Page 49: 5 Appendix Below is a shortcut key

CAD user manual - Finn-Power International, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?