NetSure ITM Installation Manual - Gruber Power

SUITABLE FO R MO UNTING O N CO NCRETE
O R O THER NO N-COMBUSTIBLE SURFACE O NLY.
SUITABLE F O R MO UNTING O N CO NCRETE
O R O THER NO N-COMBUSTIBLE SURFACE O NLY.
Electrical Connections
Figure 18 Alarm/Control Cable Interconnects (cont’d from previous page)
Note: Cabinets must be installed next
to each other, shown apart here
for clarity of control cabling
interconnections.
1 11
CAN-Bus
Black/White Wire Twisted Pair
(RPM 628 351/1)
located coiled up on right side of
2nd Expansion Module cabinet (mating
connector located on SM-DU)
Cable Runs this Direction
1 11
12
22
12
22
SEE DETAIL A
RS-485
Yellow/White Wire Twisted Pair
(RPM 628 415/2)
located coiled up on right side of
1st Expansion Module cabinet (mating
connector located on SM-AC)
Cable Runs this Direction
SEE DETAIL A
SM-DU
(Expansion Modules only)
SM-AC
LVD
Relay
Board
BLVD
LVD
Relay
Board
Cable Runs this Direction
BLVD Control Cable
(RPM 628 465/3)
Connectors
Located on
SM-DU (top view)
BLVD Control Cable
(RPM 628 466/3)
located coiled up
on right side of
Expansion Module
cabinets
Front View
1st Expansion Module
(door removed)
CAN-Bus Black/White
Wire Twisted Pair
(Expansion Module)
Front View
2nd Expansion Module
(door removed)
DETAIL A
Components Behind Cover
LVD Relay Board
Can-Bus End Resistor
(moved from Primary Module
to last Expansion Module)
DETAIL A
Components Behind Cover
LVD Relay Board
CAN-Bus
Black/White Wire
Twisted Pair
(Primary Module)
SM-DU+
SM-DU+
BLVD Control Cable
(RPM 628 465/3)
BLVD Control Cable
(RPM 628 466/3)
(Expansion Modules Only)
BLVD Control Cable
(RPM 628 465/3)
37