HAHN+KOLB-Toolcatalog 2011/12 – Metal Cutting Tools

Metal-cutting tools
Lathe tools
Indexable inserts ISO for lathe tools
Continued next page
Carbide indexable inserts
for steels up to 55 HRC
Application: intended for hard-metal types for uses from finishing to roughing in materials up to 55 HRC in continuous cutting processes.
The specially developed substrate prevents the indexable insert from breaking when used in materials of different hardness within the cut,
like e. g. case-hardened shafts.
Advantages: extremely high resistance to wear and high break strength, very cost-favourable. High cutting rate compared to CBN.
Carbide type OHC 6605
Application
steel, cast, 55 HRC
Material group
Designation
Sizes
ISO s r 17996
mm mm Ident. No. U. pr. E
CCMW 060202 0,2 010 O. R.
CCMW 060204 0,4 015 O. R.
CCMW 09T304 0,4 020 O. R.
CCMW 09T308 0,8 025 O. R.
CCMW 120404 0,4 030 O. R.
CCMW 120408 0,8 035 O. R.
CNMA 120404 0,4 040 O. R.
CNMA 120408 0,8 045 O. R.
DCMW 070202 0,2 050 O. R.
DCMW 070204 0,4 055 O. R.
DCMW 11T304 0,4 060 O. R.
DCMW 11T308 0,8 065 O. R.
DNMA 150604 0,4 070 O. R.
DNMA 150608 0,8 075 O. R.
TCMW 110204 0,4 080 O. R.
TCMW 16T304 0,4 085 O. R.
TCMW 16T308 0,8 090 O. R.
TNMA 160404 0,4 095 O. R.
TNMA 160408 0,8 100 O. R.
i Indexable inserts selection overview page 435. Prod. Gr. 133
Continued next page
CBN and PKD indexable inserts for turning
Definition: CBN (= cubic boron nitride) and PKD (= polycrystalline diamond) cutting inserts are equipped
with a carbide support and inseparably connected via a sinter process.
Advantages: excellent hardness and wear resistance properties, ultra-high cutting force, dry machining.
ABC 10/F = medium machining and finish cutting, sharp-edged for continuous cutting and for thin-walled
workpieces.
ABC 10/T = medium machining and finish cutting, with chamfer 0.15 to 15° for intermittent cuts.
ABC 25/F = finish cutting, sharp-edged for continuous cutting and for thin-walled workpieces.
ABC 25/T = medium machining and finish cutting, with chamfer 0.15 to 15° for intermittent cuts.
ADC 25/T = sharp-edged for continuous cut and convenient cut interruption.
ADC 25/F = with chamfer 0.15 to 15° for intermittent cuts.
Steel (N/mm²) Stainless st. Aluminium Brass Bronze Plastics Graphite/ Grey iron Ti Ni Super