Operating Instruction Manual SyCon System Configurator for ...
Operating Instruction Manual SyCon System Configurator for ...
Operating Instruction Manual SyCon System Configurator for ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Settings 32/132<br />
Build up TCP/IP Connection<br />
There are two possibilities to enter the IP address to build up a TCP/IP<br />
connection between the Hilscher device and the PC.<br />
• Scan network <strong>for</strong> devices<br />
Clicking on the NetIdent Rescan button, the local Ethernet network is<br />
scanned <strong>for</strong> Hilscher devices. This devices need to support the<br />
identification by the Hilscher NetIdent Protocol.<br />
Devices found during the network scan and which are connectable to<br />
the PC are displayed in the table Board Selection.<br />
• Type in IP Address manually<br />
If the device to be connected is not located in the local Ethernet<br />
network, it is necessary to type in the IP address of the device<br />
manually.<br />
Also some devices do not support the identification by the Hilscher<br />
NetIdent Protocol. In this case the IP address of the device has to be<br />
typed in manually, too.<br />
Figure 15: CIF TCP/IP Driver - Type in IP Address manually<br />
The IP address of the device to be connected need to be typed in the field<br />
Add IP Address. Clicking the Add button, it is tried to build up a CIF<br />
TCP/IP connection between the PC and the device.<br />
If a device with the typed in IP address was found, it is displayed in the<br />
table Board Selection.<br />
<strong>SyCon</strong> | <strong>System</strong> <strong>Configurator</strong> <strong>for</strong> Ethernet and serial Protocols<br />
DOC040601OI04EN | Revision 4 | English | 2012-06 | Released | Public © Hilscher, 2004-2012
Change language