Operating Instruction Manual SyCon System Configurator for ...

Settings 35/132
5.2 Parameter
5.2.1 Ethernet Parameter
The Ethernet/Protocol Parameter are the basis for the working data
exchange. This section contains information for setting the Ethernet and
Protocol Parameter and a description for the individual parameter.
Select in the following table the protocol, which you inserted in the
configuration together with the device. In the given section the settings of
the parameters are described.
Protocol Described in section Page
Ethernet Setting of the Ethernet Parameter 36
Open Modbus / TCP Setting of the Open Modbus / TCP Parameter 42
Table 19: Setting of the Ethernet Parameter
The range of parameter depends on the loaded firmware and its scope of
functions. The following table shows the parameters in dependence on the
used firmware.
Parameter
Ethernet
Device
Open
Modbus
TCP
Device
Described in section
IP Address Yes Yes IP Address 36
Ethernet Yes Yes Ethernet 37
SMTP Setup Yes No SMTP Setup 38
FTP Server Yes No FTP Server Setup 39
Setup
TCP Yes No TCP 41
Open
Modbus/TCP
No Yes Open Modbus / TCP Setup 42
Table 20: Setting of the Ethernet / Open Modbus/TCP Parameter
Page
5.2.2 Protocol Parameter
Protocol Described in section Page
ASCII Setting of the ASCII Parameter 44
3946R Setting of the 3964R Parameter 49
RK512 Setting of the RK512 Parameter 51
Modbus RTU Setting of the Modbus RTU Parameter 53
Modbus Plus Setting of the Modbus Plus Parameter 55
Modnet 1/N Setting of the Modnet 1/N Parameter 59
Modnet 1/SFB Setting of the Modnet 1/SFB Parameter 61
Table 21: Setting of the Protocol Parameter
SyCon | System Configurator for Ethernet and serial Protocols
DOC040601OI04EN | Revision 4 | English | 2012-06 | Released | Public © Hilscher, 2004-2012