PhD Fekete - SZIE version - 2.2 - Szent István Egyetem

More documents

Recommendations

Info

Materials and Methods Figure 3.10. MOM type dynamometer For data process, a Spider 8 multi-channel PC measurement electronics [HBM] was used from the HBM GmbH, which is capable for parallel dynamic data acquisition with the following parameters: • 0.1% accuracy on total range, • Maximum number of channels: 8/device, • Digital measurement rate: 9600/s/channel. The Spider is controlled by the Catman Express 3.0 program, and developed by the HBM. – 84 –
Materials and Methods 3.4.5. Measurement of the center of gravity line The experiments were carried out on 16 persons (9 males and 7 females) between 21 and 27 years old (Figure 3.11). The mean (± standard deviation) weight of all participants was 7<strong>2.2</strong> ± 17.4 kg respectively. The measurements were carried out in two parts. 9 people at the first experiment and couple of weeks later the other 7. Figure 3.11. Subjects of the experiment – 85 –
Page 1 and 2:
SZENT ISTVÁN UNIVERSITY KINETICS A
Page 3 and 4:
CONTENTS NOMENCLATURE AND ABBREVIAT
Page 5 and 6:
NOMENCLATURE AND ABBREVIATIONS F pf
Page 7 and 8:
ψ : Angle between the quadriceps t
Page 9 and 10:
v CTt : Tangential velocity compone
Page 11 and 12:
Introduction 1. INTRODUCTION AND OB
Page 13 and 14:
1.3. Aims of the PhD thesis Introdu
Page 15 and 16:
Literature review 2. LITERATURE REV
Page 17 and 18:
Literature review Figure 2.3. The f
Page 19 and 20:
Literature review Figure 2.6. Patel
Page 21 and 22:
Literature review Figure 2.8. Compo
Page 23 and 24:
Literature review The knee carries
Page 25 and 26:
Literature review For this reason,
Page 27 and 28:
Literature review Figure 2.12. Thre
Page 29 and 30:
Literature review As a short overvi
Page 31 and 32:
Literature review Moment arm 60 [mm
Page 33 and 34:
Literature review I. They demonstra
Page 35 and 36:
Literature review The presented mod
Page 37 and 38: Literature review ε angle [˚] 100
Page 39 and 40: Literature review Fpf/Fq [-] 1.2 1
Page 41 and 42: Literature review β angle [˚] Mal
Page 43 and 44: Literature review Figure 2.35. Mech
Page 45 and 46: Literature review Moment arm 60 [mm
Page 47 and 48: Literature review Let us follow the
Page 49 and 50: Literature review Finally, the pate
Page 51 and 52: Literature review Figure 2.43. Tota
Page 53 and 54: Literature review One great advanta
Page 55 and 56: Literature review Implant wear is t
Page 57 and 58: 2.3.2. General numerical models Lit
Page 59 and 60: a) The tibia plateau is a flat surf
Page 61 and 62: Literature review From their calcul
Page 63 and 64: Literature review Although a simila
Page 65 and 66: Literature review Slide/Roll [-] 1
Page 67 and 68: Literature review Figure 2.62. Mult
Page 69 and 70: Materials and Methods 3.1. Methodol
Page 71 and 72: Materials and Methods For the sake
Page 73 and 74: Materials and Methods 9 th QUESTION
Page 75 and 76: Materials and Methods 3.3. New anal
Page 77 and 78: Materials and Methods 3.3.3. Free-b
Page 79 and 80: Materials and Methods Figure 3.6. F
Page 81 and 82: Materials and Methods By the introd
Page 83 and 84: Materials and Methods 3.4. Experime
Page 85 and 86: Materials and Methods Figure 3.7. C
Page 87: Materials and Methods All of the pa
Page 91 and 92: x c Materials and Methods ∑ Fi
Page 93 and 94: Materials and Methods Probability D
Page 95 and 96: Materials and Methods Figure 3.18.
Page 97 and 98: Materials and Methods By doing so,
Page 99 and 100: 3.4.7.2. Steps of the approach Mate
Page 101 and 102: Materials and Methods All the funct
Page 103 and 104: Materials and Methods β [º] 40 20
Page 105 and 106: Materials and Methods If the center
Page 107 and 108: Materials and Methods By the use of
Page 109 and 110: Materials and Methods Thus, one pri
Page 111 and 112: Materials and Methods I. The patter
Page 113 and 114: 3.6.3. Geometrical models Materials
Page 115 and 116: Materials and Methods − − −
Page 117 and 118: 3.6.4.3. Contact [MSC.ADAMS] Materi
Page 119 and 120: Materials and Methods Besides the k
Page 121 and 122: Materials and Methods By multiplyin
Page 123 and 124: Results 4. RESULTS 4.1. Results reg
Page 125 and 126: Results This closely equal percenta
Page 127 and 128: Results Fpf/BW [-] 8 Fekete et al.
Page 129 and 130: Results In reality, human subjects
Page 131 and 132: Results 4.2. Results regarding the
Page 133 and 134: Results 0.8 Χ [-] 1 Sliding-rollin
Page 135 and 136: Results Χ [-] 1 Sliding-rolling ra
Page 137 and 138: Results Among the tested prostheses
Page 139 and 140:
Results χ [-] 1 Averaged sliding-r
Page 141 and 142:
Results Χ [-] 1 Sliding-rolling ra
Page 143 and 144:
4.3. New scientific results Results
Page 145 and 146:
Results 3 rd Thesis: Based on the m
Page 147 and 148:
Conclusions and Suggestions 5. CONC
Page 149 and 150:
Conclusions and Suggestions Suggest
Page 151 and 152:
Summary 6. SUMMARY In this doctoral
Page 153 and 154:
Appendix APPENDIX A1. Bibliography
Page 155 and 156:
Appendix [31] Csizmadia B. M., Nán
Page 157 and 158:
Appendix [61] Gill H. S., O’Conno
Page 159 and 160:
Appendix [93] Klebanov B. M., Barla
Page 161 and 162:
Appendix [123] Nägerl H., Frosch K
Page 163 and 164:
Appendix [154] Reuben J. D., McDona
Page 165 and 166:
Appendix [187] Wahrenberg H., Lindb
Page 167 and 168:
Appendix 6. Fekete G., Kátai L.: M
Page 169 and 170:
Appendix Figure 3. Setting Stitchin
Page 171 and 172:
Appendix Fpf/Fq [-] 1.2 h = 6 mm h
Page 173 and 174:
Appendix η1 angle [˚] 6 Hirokawa
Page 175 and 176:
Appendix Figure 13. Mechanical mode
Page 177 and 178:
Appendix Ψ angle [˚] 10 Van Eijde
Page 179 and 180:
Appendix Figure 19. Mechanical mode
Page 181 and 182:
Appendix - 177 -
show all

PhD Fekete - SZIE version - 2.2 - Szent István Egyetem

Create successful ePaper yourself

Delete template?

Save as template?