string

More documents

Recommendations

Info

Action Change the names of these volumes to read swap1, swap2, etc... If you still get this message after making the above change, edit the /sbin/swapadd script. Find the line: c=‘$SWAP -l | grep -c ’\\’‘ and change it to =‘$SWAP -l | grep -c ’’${special}’’‘ Also see bug number 1215062 for more information on this behavior. "P" Package not installed Cause This error occurs when users attempt to use a system call from a package which has not been installed. Technical Notes The symbolic name for this error is ENOPKG, errno=65. panic -boot: Could not mount filesystem Cause The primary problem is that jumpstart gives the following error: 2ec00 RPC: Can’t decode result. whoami RPC call failed with rpc status: 2 (continued) 150 Solaris Common Messages and Troubleshooting Guide ♦ October, 1998
(Continuation) panic - boot: Could not mount filesystem. program terminated ok Normally this is a result of the bootparams not being able to get to the install image. The second problem is that other users have had the same error message, with the additional message: ’Timeout waiting for ARP/RARP packet...’ Action To solve the first problem: 1. Check how the dfstab(4) (/etc/dfs/dfstab on the install image NFS server) looks: share -F nfs -o ro,anon=o /jumpstart-dir 2. Run share(1M) command on the installed image NFS server, to make sure it is shared properly. 3. Check /etc/bootparams file on the net install server. Look for entries with incorrect boot path. 4. Make sure that /usr/sbin/rpc.bootparamd is running on the boot server. If necessary, kill and restart it. 5. Check /etc/ethers on the boot server for duplicate or conflicting entries 6. At OK prompt, run test net /test-net and/or watch net /watch-net to test the network connectivity A workaround for the second problem is to check the nsswitch.conf(4) file. If some of the entries point to NIS such as: rpc nis files hosts nis files ethers nis files bootparams files nis Alphabetical Message Listing 151
Page 1 and 2:
Solaris Common Messages and Trouble
Page 3 and 4:
Contents Preface xxi 1. About Error
Page 5 and 6:
"C" 30 bad module/chip at: position
Page 7 and 8:
"E" 58 Device busy 50 device busy 5
Page 9 and 10:
"H" 77 "I" 80 giving up 76 Graphics
Page 11 and 12:
le0: No carrier-- cable disconnecte
Page 13 and 14:
Network is down 120 Network is unre
Page 15 and 16:
Operation not applicable 147 "P" 15
Page 17 and 18:
Slice c0t1d0s0 is too small to cont
Page 19 and 20:
user unknown 195 /usr/dt/bin/rpc.tt
Page 21 and 22:
Preface System administrators and a
Page 23:
TABLE P-1 Typographic Conventions (
Page 26 and 27:
Variable words and numbers can appe
Page 28 and 29:
TABLE 1-2 AnswerBook Search Results
Page 30 and 31:
6 Solaris Common Messages and Troub
Page 32 and 33:
** Phase 1-- Check Blocks and Sizes
Page 34 and 35:
** Phase 4-- Check Reference Counts
Page 36 and 37:
451 timeout waiting for input durin
Page 38 and 39:
Action Check the value of the $j ma
Page 40 and 41:
Address already in use Cause User a
Page 42 and 43:
Arg list too long Cause The system
Page 44 and 45:
Attempting to link in more shared l
Page 46 and 47:
BAD/DUP FILE I=i OWNER=o MODE=m SIZ
Page 48 and 49:
Action Replace the memory module or
Page 50 and 51:
BAD TRAP Cause A bad trap can indic
Page 52 and 53:
oot error 13 | sun4m Cause Diskless
Page 54 and 55:
"C" Cannot access a needed shared l
Page 56 and 57:
Cannot find SERVER hostname in netw
Page 58 and 59:
Action If print jobs are coming out
Page 60 and 61:
cd: Too many arguments Cause The C
Page 62 and 63:
Communication error on send Cause T
Page 64 and 65:
Technical Notes The symbolic name f
Page 66 and 67:
Technical Notes Some signals, such
Page 68 and 69:
Could not initialize tooltalk (tt_o
Page 70 and 71:
cpio : can’t read input : end of
Page 72 and 73:
¤ See the message "BAD TRAP" for m
Page 74 and 75:
dev/rdsk/c0t6d0s2: No such file or
Page 76 and 77:
# ./volmgt stop # ps -ef | grep vol
Page 78 and 79:
Action To remove the directory, fir
Page 80 and 81:
# ls -lL /dev/rdsk/c2t0d0s1 crw----
Page 82 and 83:
See Also For more information, see
Page 84 and 85:
Error 76 Cause This error is RFS sp
Page 86 and 87:
Error Host Unknown: Cause On Window
Page 88 and 89:
Action Run vxserial -p to print the
Page 90 and 91:
Exec format error Cause This often
Page 92 and 93:
fd0: unformatted diskette or no dis
Page 94 and 95:
Action Have the original owner chan
Page 96 and 97:
Action Simply waiting often gives t
Page 98 and 99:
ftp: ftp/tcp: unknown service Cause
Page 100 and 101:
"G" giving up Cause This message ap
Page 102 and 103:
home/string: No such file or direct
Page 104 and 105:
"I" I can’t read your attachments
Page 106 and 107:
ifconfig: bad address Cause System
Page 108 and 109:
Technical Notes Sometimes this cond
Page 110 and 111:
INCORRECT BLOCK COUNT I=int (should
Page 112 and 113:
inetd[int]: string/udp: unknown ser
Page 114 and 115:
Interrupted system call Cause The u
Page 116 and 117:
I/O error Cause Some physical Input
Page 118 and 119:
"K" kernel read error Cause This me
Page 120 and 121:
ld.so.1 fatal: can’t set protecti
Page 122 and 123:
Technical Notes This error does not
Page 124 and 125: When a machine is configured as a n
Page 126 and 127: Link has been severed Cause This er
Page 128 and 129: If you cannot log in to the system
Page 130 and 131: mailtool: Could not initialize the
Page 132 and 133: mailtool: Can’t create dead lette
Page 134 and 135: file name may contain holes - can
Page 136 and 137: mount: /dev/dsk/string is already m
Page 138 and 139: Multihop attempted Cause This error
Page 140 and 141: Action Run /etc/mount to see if the
Page 142 and 143: "N" Name not unique on network Caus
Page 144 and 145: Network dropped connection because
Page 146 and 147: nfs mount: Couldn’t bind to reser
Page 148 and 149: NFS read failed for server string C
Page 150 and 151: NFS string failed for server string
Page 152 and 153: NIS+ authentication failure Cause T
Page 154 and 155: Technical Notes A wait(2) system ca
Page 156 and 157: No recipients specified Cause This
Page 158 and 159: filesystem and create symbolic link
Page 160 and 161: Action Make sure the NIS map name i
Page 162 and 163: Not a stream device Cause A putmsg(
Page 164 and 165: (Continuation) (ssd22): Error for C
Page 166 and 167: Not on system console Cause A user
Page 168 and 169: 6/04/98 7:27:54 nsrck: SYSTEM error
Page 170 and 171: Operation already in progress Cause
Page 172 and 173: Operation now in progress Cause An
Page 176 and 177: change all of these entries to file
Page 178 and 179: See Also For more information, see
Page 180 and 181: Permission denied Cause An attempt
Page 182 and 183: Protocol not supported Cause The re
Page 184 and 185: Read-only file system Cause Files a
Page 186 and 187: To increase the size of the process
Page 188 and 189: mdir: string: Directory not empty C
Page 190 and 191: "S" save: SYSTEM error, Arg list to
Page 192 and 193: Security exception on host string.
Page 194 and 195: sendmail[int]: NOQUEUE: SYSERR: net
Page 196 and 197: Your attempt to attach metastate da
Page 198 and 199: Srmount error Cause This error is R
Page 200 and 201: Technical Notes The rcp(1) and rsh(
Page 202 and 203: su: ’su root’ succeeded for str
Page 204 and 205: system hang Cause 4.1.3C SBUS cards
Page 206 and 207: Text file busy Cause This can occur
Page 208 and 209: See Also For more information, see
Page 210 and 211: Action If you choose "Save Changes,
Page 212 and 213: Action You can control the soft lim
Page 214 and 215: 6. The boot block is probably bad t
Page 216 and 217: Unable to install/attach driver ’
Page 218 and 219: Action Correct the command line and
Page 220 and 221: usr/openwin/bin/xinit: connection t
Page 222 and 223: "V" Value too large for defined dat
Page 224 and 225:
Action Check the date on the system
Page 226 and 227:
WARNING: No network locking on stri
Page 228 and 229:
WARNING: Unable to repair the / fil
Page 230 and 231:
Action On some system architectures
Page 232 and 233:
tried to run on the X server specif
Page 234 and 235:
XView warning: Cannot load font set
Page 236 and 237:
the ypwhich(1) command. When the se
show all

string

Create successful ePaper yourself

Delete template?

Save as template?