string

Action
If print jobs are coming out of the printer in question, wait until they are finished
and then resubmit this print job. If you see this message again, the lp(1) system is
probably hung.
See the message "lp hang" for a procedure to clear the queue.
Technical Notes
If lp(1) is unable to create a device for printer messages, the message FIFO could be
already in use, or locked by another print job.
See Also
For more information on the print scheduler, see the section on administrating
printers in the System Administration Guide Volume II.
Can’t invoke /etc/init, error int
Cause
This message can appear while a system is booting, indicating that the init(1M)
program is missing or corrupted. Note that /etc/init is a symbolic link to
/sbin/init.
Action
Boot the miniroot so you can replace init(1M). Halt the machine by typing
Stop-A or by pressing the reset button. Reboot single-user from CD-ROM, the net,
or diskette. For example, type boot cdrom -s at the ok prompt to boot from
CD-ROM. After the system comes up and gives you a # prompt, mount the device
corresponding to the original / partition somewhere, with a command similar to the
mount(1M) command below. Then copy the init(1M) program from the miniroot
to the original / partition, and reboot the system.
# mount /dev/dsk/c0t3d0s0 /mnt
# cp /sbin/init /mnt/sbin/init
# reboot
34 Solaris Common Messages and Troubleshooting Guide ♦ October, 1998