string

dev/rdsk/c0t6d0s2: No such file or
directory
Cause
When attempting to eject a CD-ROM on a Ultra 450 system, the eject cdrom
command fails, displaying the error message.
This is because the CD-ROM is on controller 1 not 0. For the eject(1) command,
the cdrom "nickname" equates to /dev/rdsk/c0t6d0s2. On an Ultra 450, the
CD-ROM is /dev/rdsk/c1t6d0s2. So, using cdrom does not work.
Action
Use the following command instead:
# eject cdrom0
If volume manager (/usr/sbin/vold) is not running, you can use:
# eject /dev/rdsk/c1t6d0s2
Note: Make sure that the front panel of the system is unobstructed so that the
CD-ROM tray is not blocked. Otherwise, the eject(1) command appears to hang
since the tray is trying to open but is physically blocked.
Device busy
Cause
An attempt was made to mount a device that was already mounted or to unmount a
device containing an active file (such as an open file, a current directory, a mount
point, or a running program). This message also occurs when trying to enable
accounting that is already enabled.
Action
To unmount a device containing active processes, close all the files under that mount
point, quit any programs started from there, and change directories out of that
hierarchy. Then try to unmount again.
50 Solaris Common Messages and Troubleshooting Guide ♦ October, 1998