Tornado

5
Shell
Table 5-7
WindSh Commands for Object Display (Continued)
Call
smMemPartShow( )
moduleShow( )
moduleIdFigure()
intVecShow( )
Description
Display the amount of free space and statistics on memoryblock
allocation for a specified shared-memory partition.
Show the current status for all the loaded modules.
Report a loaded module’s module ID, given its name.
Display the interrupt vector table. This routine displays
information about the given vector or the whole interrupt vector
table if vector is equal to -1. Note that intVecShow( ) is not
supported on architectures such as ARM and PowerPC that do
not use interrupt vectors.
5
Network Status Display
Table 5-8 summarizes the WindSh commands that display information about the
VxWorks network.
Table 5-8
WindSh Commands for Network Status Display
Call
hostShow( )
icmpstatShow( )
ifShow( )
inetstatShow( )
ipstatShow( )
routestatShow( )
tcpstatShow( )
tftpInfoShow( )
udpstatShow( )
Description
Display the host table.
Display statistics for ICMP (Internet Control Message Protocol).
Display the attached network interfaces.
Display all active connections for Internet protocol sockets.
Display IP statistics.
Display routing statistics.
Display all statistics for the TCP protocol.
Get TFTP status information.
Display statistics for the UDP protocol.
In order for a protocol-specific command to work, the appropriate protocol must
be included in your VxWorks configuration.
167