Tornado

2
Setup and Startup
blank fields, although this illustration shows them for completeness.)
boot device
: ln
processor number : 0
host name
: mars
file name
: /usr/wind/target/config/bspname/vxWorks
inet on ethernet (e) : 90.0.0.50
inet on backplane (b) :
host inet (h) : 90.0.0.1
gateway inet (g) :
user (u)
: fred
ftp password (pw)(blank=use rsh) :
flags (f)
: 0x0
target name (tn) : phobos
startup script (s) :
other (o) :
2
Figure 2-7
Boot Configuration Example
HOST
/usr/wind/target/config/bspname/vxWorks
TARGET
mars
phobos
user: fred
90.0.0.1
Ethernet
90.0.0.50
To change the boot parameters, type c at the boot prompt, as follows:
[VxWorks Boot]: c
In response, the boot program prompts you for each parameter. If a particular field
has the correct value already, press RETURN. To clear a field, enter a period ( . ),
then RETURN. If you want to quit before completing all parameters, type CTRL+D.
Network information must be entered to match your particular system
configuration. The Internet addresses must match those in /etc/hosts on your
UNIX host, as described in Establishing the VxWorks System Name and Address, p.27.
If your target has nonvolatile RAM (NVRAM), boot parameters are retained there
even if power is turned off. For each subsequent power-on or system reset, the boot
program uses these stored parameters for the automatic boot configuration.
47