EFM User Manual - CTC Union Technologies Co.,Ltd.

More documents

Recommendations

Info

BE (Best Effort) is used for data applications or any non-classified traffic. This would include e-mail, Internet browsing, data back-up etc. The BE class is for traffic that can afford to wait and not affect the overall outcome of the data application. WRR (Weight Round Robin) services on a rotating basis and is activated only when a port has more traffic than it can handle. A queue is a given an amount of bandwidth irrespective of the incoming traffic on that port. The queue then moves to the back of the list. The next queue is given an equal amount of bandwidth, and then moves to the end of the list, and so on, depending on the number of queues being used. This works in a looping fashion until a queue is empty. 42
3.5.3.2 VLAN Tag Priority When you click VLAN Tag Priority, it will show the following: VLAN Tag Priority uses the tag field information which has been inserted into an Ethernet frame. If a port has an 802.1Q-compliant device attached (such as this modem), these tagged frames can carry VLAN membership information. IEEE 802.1Q Tagged Frame for Ethernet: <strong>User</strong> priority is giving eight ( 2 3 = 8 ) priority levels. The default value is 0, indicating normal treatment. 43
Page 1: G.SHDSL.bis EFM Network Extender
Page 4 and 5: Legal The information in this publi
Page 6 and 7: 3.5.2 VLAN.........................
Page 8 and 9: 4.10 ADMINISTRATION................
Page 10 and 11: 1.2 Features Extend Ether
Page 12 and 13: 1.4 Applications EFM DSLAM to point
Page 14 and 15: LED status of EFM Modem : LEDs Acti
Page 16 and 17: 2.2.2 LAN ports and MGMT port The E
Page 18 and 19: 3 Configuration use Web Browser 3.1
Page 20 and 21: 3.3 Setup up with Web Browser This
Page 22 and 23: The diagram below shows the basic s
Page 24 and 25: 3.4.2 DHCP server Press Next to set
Page 26 and 27: 3.4.3 LAN Press Next to set the nex
Page 28 and 29: 3.5 Advanced Setup Note: The advanc
Page 30 and 31: 3.5.1.5 SNR margin SNR margin is an
Page 33 and 34: 3.5.2.1 802.1Q Tag-Based VLAN Click
Page 35 and 36: Before enabling VLANs for the EFM m
Page 37 and 38: The default setting is all ports co
Page 39 and 40: On devices of different vendors, th
Page 41: 3.5.3.1 Port Based Priority When yo
Page 45 and 46: According to the previous two table
Page 47 and 48: The following is an illustration ab
Page 49 and 50: 3.5.4 Rate Control Click Rate Contr
Page 51 and 52: The below display screen is from a
Page 53 and 54: 3.6.3 LAN LAN status will display t
Page 55 and 56: 3.7 Administration This session int
Page 57 and 58: Legal address pool will setup the l
Page 59 and 60: 3.7.2.1 Community Pool To enable th
Page 61 and 62: 3.8 Utility This section will descr
Page 63 and 64: 3.8.2 Config Tool The configuration
Page 65 and 66: 3.8.4 Logout To exit the web config
Page 67 and 68: 4 Configuration use Serial Console
Page 69 and 70: The following figure gives you an e
Page 71 and 72: If you are the authorized user, you
Page 73 and 74: Command Description: Command enable
Page 75 and 76: 4.4.1.3 Annex There are two types o
Page 77 and 78: 4.4.3 VLAN Virtual LAN (VLAN) is de
Page 79 and 80: Access Trunk The port can receive o
Page 81 and 82: 4.4.4.2 Queue weight This setting c
Page 83 and 84: 4.4.4.5 VLAN Tag Priority QoS -----
Page 85 and 86: 4.4.5 RATE Move the cursor " >> " t
Page 87 and 88: To configure DHCP server, move the
Page 89 and 90: 4.4.9 Host name A Host Name is the
Page 91 and 92: 4.5.2 Interface Move cursor " >> "
Page 93 and 94:
4.9 Ping Ping command can use to di
Page 95 and 96:
Move the cursor ">>" to attrib and
Page 97 and 98:
4.10.3 SNMP Simple Network Manageme
Page 99 and 100:
SNMP Trap Host: Trap Host entry(1~5
Page 101 and 102:
4.11.1 Upgrade main software Move t
Page 103 and 104:
5 Appendix - Setup table SHDSL.bis:
Page 105 and 106:
QoS Mode: QoS Mode □Disable □Po
Page 107:
SNMP Community: SNMP entry (1) Vali
show all

EFM User Manual - CTC Union Technologies Co.,Ltd.

Create successful ePaper yourself

Delete template?

Save as template?