Phoenix Contact INTERFACE System Cabling and ... - Power/mation

INTERFACE Cabling
VARIOFACE wiring interface
Solid-state relay OV
Solid-state relays for electrical isolation
can be mounted directly on the printed
circuit board as interfaces or plugged in
using the solder-in socket SIM-AMS.
The solid-state relays are suitable for
switching ohmic, capacitive or inductive
loads. Relays for switching AC circuits have
a zero voltage switch to switch the load on
in the zero voltage crossing. It is switched
off in the zero current crossing. The
integrated RC element permits operation
up to cos ϕ = 0.5.
Inductive DC loads must be equipped
with a fast-acting free-wheeling diode for
semiconductor relay protection.
– Switching capacity up to 350 V DC/1 A,
60 V DC/4 A or 480 V AC/5 A
– No wear and tear, even with high
switching frequencies,
– No contact bounce – no movable parts,
– No electromagnetic interference,
– Electrically insulated housings,
– Small dimensions,
– High test voltage of 4 kV between control
and load circuits.
Note:
For derating curves, see page 316.
For suitable bases, refer to page 312.
1 ) Turn-on/off time at U N : Max. ½ period
5,9 25,4
7,6
Description
OUTPUT
43,2
INPUT
3 4 1 (+) 2
17,8
30,5
35,5
1,1
7,7
10,5
Width 10.5
OV-24DC/350DC/1
With DC voltage output
max. = 1 A
1 3
+ +
-
2 4
Input voltage
U N
Type Order No.
Solid-state relay for signal amplification and electrical isolation of
the control and load circuits, pluggable in the solder-in plug-in base
SIM-AMS or with PCB connection for direct mounting onto the
PCB,
Input: DC voltage
Output: DC voltage
1 24 V DC OV-24DC/350DC/1 2982634 10
Solid-state relay, same as before, however
Input: DC voltage
Output: AC voltage
1 24 V DC
Technical data 1
Input data
Input voltage range
4.25 V DC ... 32 V DC
Switching level 1 signal ("H") [V DC] ≥ 3.3
0 signal ("L") [V DC] ≤ 1
Typ. input current at U N [mA] 15
Typ. turn-on time for U N [µs] 100
Typ. turn-off time at U N [µs] 250
Transmission frequency f limit [Hz] 100
Output data
Operating voltage range
1 V DC ... 350 V DC
Periodic peak reverse voltage -
Limiting continuous current
1 A (see derating curve)
Min. load current
1 mA
Surge current 20 A (tp = 1 s)
Residual voltage drop at "H"
0.5 V
Leakage current in off condition 100 µA
Phase angle (cos ϕ) -
Max. load value -
Output protection
Polarity protection
General data
Test voltage input/output
4 kV (50 Hz, 1 min)
Ambient temperature range -20°C ... 80°C
Standards/regulations
EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 55011, basic
insulation
Assembly position/mounting
Any / Can be aligned with > 9 mm spacing
Dimensions W / H / D 10.5 mm / 25.4 mm / 43 mm
u
Pcs. /
Pkt.
310 PHOENIX CONTACT
Courtesy of Power/mation. 1310 Energy Lane, Saint Paul, MN 55108
info@powermation.com - 800-843-9859 - www.powermation.com