Automating Manufacturing Systems - Process Control and ...

plc timers - 9.28
• MCRs can force off a section of ladder logic.
9.9 PRACTICE PROBLEMS
1. What does edge triggered mean? What is the difference between positive and negative edge
triggered?
2. Are reset instructions necessary for all timers and counters?
3. What are the numerical limits for typical timers and counters?
4. If a counter goes below the bottom limit which counter bit will turn on?
5. a) Write ladder logic for a motor starter that has a start and stop button that uses latches. b)
Write the same ladder logic without latches.
6. Use a timing diagram to explain how an on delay and off delay timer are different.
7. For the retentive off timer below, draw out the status bits.
A
RTF
Timer T4:0
Time Base 0.01
Preset 350
Accum. 0
(DN)
(EN)
A
T4:0/EN
T4:0/DN
T4:0/TT
T4:0.Accum.
0 3 6 10 16 18 20