Automating Manufacturing Systems - Process Control and ...

plc wiring - 2.13
When the L coil is energized, x will be toggled on, it will stay on until the U coil
is energized. This is like a flip-flop and stays set even when the PLC is turned off.
x
x
L
U
Some PLCs will allow immediate outputs that do not wait for the program scan to
end before setting an output. (Note: This instruction will only update the outputs using
the output table, other instruction must change the individual outputs.)
IOT
x
Note: Outputs are also commonly shown using parentheses -( )- instead of
the circle. This is because many of the programming systems are text
based and circles cannot be drawn.
Figure 2.12
Ladder Logic Outputs
2.2 A CASE STUDY
Problem: Try to develop (without looking at the solution) a relay based controller
that will allow three switches in a room to control a single light.