25.05.2014 Views

PDF catalog - Who-sells-it.com

PDF catalog - Who-sells-it.com

PDF catalog - Who-sells-it.com

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Transmissions & Components<br />

Tools & Books<br />

Manual Transmissions<br />

Differential Components<br />

12581400<br />

F23 Manual Transmission ‘05-’07 Cobalt/G5 (not<br />

shown)<br />

• Non-supercharged applications<br />

• 3.84 ratio<br />

19213181<br />

T-56 Transmission K<strong>it</strong> (not shown)<br />

• For Big-Block and Gen I and II Small-Blocks<br />

• Gear ratios: 1st: 2.66, 2nd: 1.78, 3rd: 1.30, 4th: 1.00,<br />

5th: 0.74, 6th: 0.50<br />

• Includes shifter, no handle<br />

19213178<br />

T-56 Transmission K<strong>it</strong> (not shown)<br />

• For Gen III and IV Small-Blocks (LS series)<br />

• Gear ratios: 1st: 2.66, 2nd: 1.78, 3rd: 1.30, 4th: 1.00,<br />

5th: 0.74, 6th: 0.50<br />

• Includes shifter, no handle<br />

Controllers and Accessories<br />

A. 12497316<br />

Transmission Controller, 4L60-E, 4L65-E, 4L80-E<br />

and 4L85-E Automatic<br />

• Required when using a GM electronically controlled<br />

automatic transmission (see page 297)<br />

• Includes wiring harness, software and connector for<br />

lap-top <strong>com</strong>puter<br />

• Controller allows full programming of shifting, as well as<br />

part-throttle, wide-open throttle and shift firmness control<br />

• Comes pre-programmed—simply enter rear tire diameter<br />

and axle ratio<br />

• Wiring harness P/N 124894 included<br />

19212657 NEW<br />

Transmission Controller, 4L60-E, 4L65-E, 4L80-E<br />

and 4L85-E Automatic (not shown)<br />

• Required when using a GM electronically controlled<br />

automatic transmission (see page 297)<br />

• Includes wiring harness, software and connector for<br />

lap-top <strong>com</strong>puter<br />

• Controller allows full programming of shifting, as well as<br />

part-throttle, wide-open throttle and shift firmness control<br />

A Transmission Controller, 4L60-E, 4L65-E, 4L80-E and 4L85-E Automatic<br />

B<br />

4L60/700R4 Transmission Swap K<strong>it</strong><br />

Engine Lift Bracket K<strong>it</strong><br />

G<br />

Piston<br />

Engine Oil Primer<br />

H<br />

I<br />

E. 88958682<br />

Torsen Differential<br />

• Used in GM 4T65E Racing’s FWD drag racing programs<br />

• Tested to 900-plus horsepower<br />

• In drag-race style, straight-line acceleration runs, this<br />

results in a close to ideal 50/50 power spl<strong>it</strong> to both<br />

drive wheels<br />

• In cornering, while accelerating out of a turn, the Torsen<br />

biases power to the outside wheel, reducing insidewheel<br />

spin<br />

• Provides constant and infin<strong>it</strong>ely variable drive<br />

• Power is transferred automatically w<strong>it</strong>hout the use of<br />

normal friction<br />

• Extremely strong and durable, because <strong>it</strong> is gear operated<br />

• No plates or clutches that can wear out<br />

• Comes w<strong>it</strong>h new pinion gears already loaded<br />

F. 12498974<br />

8.625” Differential Cover<br />

• Heavy duty cast-aluminum differential cover to f<strong>it</strong> your<br />

CK 1500 series truck<br />

• Doubles the fluid capac<strong>it</strong>y of the differential allowing<br />

<strong>it</strong> to run cooler and ultimately extending the life of<br />

the differential<br />

• Be sure to add the proper amount of fluid, see instructions<br />

Tools<br />

G. 12363238<br />

Engine Lift Bracket K<strong>it</strong><br />

• Bolt to the ends of cylinder heads for secure removal<br />

or installation<br />

• Contains two 7/16" thick brackets<br />

NOTE: Must use w<strong>it</strong>h Grade 5 or higher bolts.<br />

H. 12364087<br />

Piston Stop<br />

• Helps pos<strong>it</strong>ively locate piston at Top Dead Center (TDC)<br />

during camshaft degreeing<br />

• Made from brass w<strong>it</strong>h drilled center to vent cylinder<br />

pressure<br />

• Screws into spark plug hole<br />

Tools & Racetrack Accessories<br />

B. 24502513<br />

4L60/700R4 Transmission Swap K<strong>it</strong><br />

• Adapts the 4L60 or 700R4 automatic transmission<br />

(non-electronic version) for use in early-model vehicles,<br />

w<strong>it</strong>h or w<strong>it</strong>hout an engine management <strong>com</strong>puter<br />

• Includes instruction sheet, throttle valve spring for<br />

carbureted engines, a normally-closed fourth-gear clutch<br />

sw<strong>it</strong>ch and wiring connector for the torque converter<br />

C. 12563532<br />

Crankshaft Spacer<br />

• For use w<strong>it</strong>h Gen I style (Turbo 350/400, 700R4,<br />

4L60, 4L60E and 4L85E) transmission on Gen III- and<br />

Gen IV-engines<br />

• Needs regular flat flexplate P/N 1255136 and six torque<br />

converter bolts P/N 11589040 or starter will not reach<br />

• Also requires longer bolts P/N 12563533<br />

D. 19154766<br />

Transmission Adapter K<strong>it</strong><br />

• Allows installation of Gen III/IV style 4L60E/4L65E<br />

transmission onto Gen I and II engine<br />

• Includes spacer ring, shims, dowels, bolts and flexplate<br />

• Works on 1-piece rear main seal engines only<br />

C<br />

Crankshaft Spacer<br />

D<br />

Transmission Adapter K<strong>it</strong><br />

Rocker Arm Ratio Checking Tool<br />

J<br />

I. 12368084<br />

Engine Oil Primer<br />

• Lubricates bearings prior to start-up of new or rebuilt engine<br />

• For use on all Gen I and Gen II Chevy Small-Block V-8, all<br />

Big-Block V-8 and all V-6 engines<br />

12346004<br />

Pipe Sealant (50cc, not shown)<br />

• GM-re<strong>com</strong>mended sealant<br />

J. 88958663<br />

Rocker Arm Ratio Checking Tool<br />

• Checks 1.5 and 1.6 aluminum rocker arm ratios<br />

• For use only w<strong>it</strong>h GM Performance Parts aluminum<br />

rocker arms<br />

NOTE: Intended for use by racing sanctioning bodies.<br />

K. 12364088<br />

Valvetrain Organizer Tray<br />

• Keeps your engine’s valvetrain <strong>com</strong>ponents correctly<br />

organized<br />

• W<strong>it</strong>h provisions for rocker arms, pushrods, adjusting<br />

nuts and lifters<br />

E<br />

Torsen Differential<br />

F<br />

8.625" Differential Cover<br />

Valvetrain Organizer Tray<br />

K<br />

298 Buy online at www.gmperformanceparts.<strong>com</strong><br />

Available for purchase online at<br />

gmperformanceparts.<strong>com</strong><br />

299

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!