Owners Manual - Roland

More documents

Recommendations

Info

Getting Ready Placing the VR-700 on the KS-G8 Stand If you place the VR-700 on a stand, you must use the KS-G8 (sold separately). • When placing the VR-700 on the stand, be careful not to pinch your fingers between the instrument and the stand. • When lifting the VR-700 onto the stand, make sure to enlist the help of at least one other person. • Using the VR-700 with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and resulting in injury or damage. • For details on how to assemble the stand, refer to the owner’s manual that accompanied the stand. fig.VKvsKS-G8.eps Front (keyboard) side A B Top view B A C Rear panel side C 1. Place the VR-700 in the position shown in the illustration. • Position rubber feet “A” on the outside of the stand’s rubber pads. • Position rubber feet “B” directly above the stand’s arms. • Position rubber feet “C” so that they contact the inside of the stand’s rubber pads. * Make sure that the VR-700’s six rubber feet (A–C) are not resting on the stand’s rubber pads. Connecting the Power Cord 1. Before you begin making connections, confirm the following. • Is the volume level of the VR-700 or connected amp turned all the way down? • Is the power to the VR-700 or connected amp turned off? 2. Connect the supplied power cord to the AC Inlet of the VR-700, and plug the other end into an AC outlet. fig.ConnectPowerCoad.eps Rear panel 18
Getting Ready Turning the Power On/Off Turning the Power On Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/ or damage to speakers and other devices. Turning the Power Off 1. Turn the [VOLUME] knob to the minimum position before you turn off the power. fig.VolMin.eps Also minimize the volume of any connected external equipment. 1. Before you turn on the power, make sure that the [VOLUME] knob is turned all the way down. fig.VolMin.eps Also minimize the volume of any connected external audio equipment. 2. Switch off the power to any connected external equipment. 3. To turn the power off, press the lower part of the [POWER] switch located on the VR-700’s rear panel. 2. To turn the power on, press the upper part of the [POWER] switch located on the VR-700’s rear panel. fig.P-On.eps * If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to “Power Supply” (p. 6). The power will turn on, and the display will light up. * Minimize the volume before you turn on the power. Even if the volume is minimized, you may hear sound when turning on the power, but this does not indicate a malfunction. * Due to a circuitry-protection feature, this unit requires a few moments after it has been powered up before it is ready for normal operation. * If the power is turned off while a Factory Reset is being executed (p. 26), the internal data will be lost, and it may take some time to start up the next time you switch on the VR-700’s power. 3. Switch on the power to any external equipment that is connected. 4. Adjust the volume of any external equipment that is connected. 5. Adjust the VR-700’s volume to an appropriate level. 19
Page 1 and 2: WARNING: To reduce the risk of fire
Page 3 and 4: USING THE UNIT SAFELY • Do not al
Page 5 and 6: IMPORTANT NOTES Additional Precauti
Page 7 and 8: Creating Organ Sounds .............
Page 9 and 10: * The MIDI implementation is availa
Page 11 and 12: Features of the VR-700 Ensemble sec
Page 13 and 14: Names of Things and What They Do fi
Page 15: Names of Things and What They Do Re
Page 19 and 20: Getting Ready Connecting Playback E
Page 21 and 22: Getting Ready Adjusting the Volume
Page 23 and 24: Getting Ready Disabling Panel Opera
Page 25 and 26: Playing the VR-700 About the VR-700
Page 27 and 28: Playing the VR-700 Playing Organ So
Page 29 and 30: Playing the VR-700 The ensemble sou
Page 31 and 32: Playing the VR-700 Playing Organ So
Page 33 and 34: Playing the VR-700 Boundary Between
Page 35 and 36: Playing the VR-700 What is the Whee
Page 37 and 38: Creating Organ Sounds Using the Har
Page 39 and 40: Creating Organ Sounds Using Percuss
Page 41 and 42: Creating Organ Sounds Adding Rotary
Page 43 and 44: Creating Organ Sounds Using a Pedal
Page 45 and 46: Storing Your Favorite Settings (Fav
Page 47 and 48: Playing Rhythms and Songs (Player F
Page 49 and 50: Various Settings (Function mode) Op
Page 51 and 52: Various Settings (Function mode) Ro
Page 53 and 54: Various Settings (Function mode) Fu
Page 55 and 56: Various Settings (Function mode) MI
Page 57 and 58: Various Settings (Function mode) Sy
Page 59 and 60: Various Settings (Function mode) De
Page 61 and 62: Appendix 63
Page 63 and 64: Connecting MIDI Equipment * To prev
Page 65 and 66: Connecting MIDI Equipment Connectin
Page 67 and 68:
Ensemble Sound List No. Tone Name M
Page 69 and 70:
Internal Rhythm Pattern List No. Na
Page 71 and 72:
List of Effects for the Ensemble So
Page 73 and 74:
List of the Factory Installed Favor
Page 75 and 76:
Troubleshooting If you think there
Page 77 and 78:
Error Messages Indication Situation
Page 79 and 80:
Specifications Weight (not includes
Page 81 and 82:
Index P Part ......................
Page 83 and 84:
For EU Countries For China 85
show all

Owners Manual - Roland

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?