Owners Manual - Roland
Owners Manual - Roland
Owners Manual - Roland
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Various Settings (Function mode)<br />
Operations in Function Mode<br />
1. Press the [FUNCTION/ENTER] button.<br />
The VR-700 will enter Function mode, and the display will indicate<br />
.<br />
2. Use the [+] button or [–] button to select the group<br />
containing the parameter you want to edit.<br />
The sound buttons will blink.<br />
Display Group Refer to...<br />
Editing Parameter Values<br />
You can edit the value of a parameter by using the [–] button or [+]<br />
button.<br />
Depending on how you press these buttons, the value will change<br />
as follows.<br />
Operation<br />
Press the [+] button<br />
Press the [–] button<br />
Hold down the [+] button<br />
Change in value<br />
Value increases<br />
Value decreases<br />
Value continues increasing<br />
Organ sound parameters p. 52<br />
Percussion parameters p. 52<br />
Rotary parameters p. 53<br />
Hold down the [–] button<br />
Hold down the [+] button and<br />
press the [–] button<br />
Hold down the [–] button and<br />
press the [+] button<br />
Press the [+] button and [–]<br />
button simultaneously<br />
Value continues decreasing<br />
Value increases rapidly<br />
Value decreases rapidly<br />
Value is reset to the factory-set value<br />
Ensemble sound parameters p. 53<br />
Equalizer settings p. 54<br />
Pedal, bend lever, and foot<br />
controller settings<br />
p. 54<br />
* The factory settings of the system parameters are listed in the table<br />
on the next and following pages.<br />
* In the case of parameters stored as a Favorite, pressing the [–]<br />
button and [+] button simultaneously will reset the parameter to a<br />
certain value, but please be aware that this is not the value stored in<br />
the Favorite settings.<br />
Player parameters p. 56<br />
MIDI input/output settings p. 57<br />
System settings p. 59<br />
V-LINK settings p. 60<br />
Confirming System Parameters<br />
Of the parameters that can be set in Function mode, some<br />
parameters are stored as part of the system. The setting changes<br />
you make for such system parameters can be stored by carrying out<br />
the following procedure.<br />
1. Edit the value of the parameter.<br />
Deleting favorite sets,<br />
formatting USB memory,<br />
initializing the system<br />
p. 60<br />
2. Press the [WRITE] button.<br />
The display will indicate .<br />
3. After you’ve selected the group, press the sound button<br />
that corresponds to the parameter that you want to edit.<br />
For the correspondence between parameters and sound buttons,<br />
refer to the pages listed above.<br />
3. To write the edited value into memory, press the<br />
[FUNCTION/ENTER] button.<br />
If you decide not to write the edited value, press [DISPLAY/EXIT].<br />
4. Use the [+] button or [–] button to edit the value of the<br />
parameter.<br />
5. When you’ve finished editing, press the [DISPLAY/EXIT]<br />
button to return to the state of selecting a group.<br />
6. Press the [DISPLAY/EXIT] button once again to exit<br />
Function mode.<br />
51