Electrical Schematics (EST 100 ... - UAW-Chrysler.com

,1'8675,$/$8720$7,21
&1&6(783 23(5$7,21)250,//6
October 2003-September 2004
&2856(&17
2 Hours
&2856('(6&5,37,21
This course covers the programming and operation fundamentals of the Bridgeport EZ-Trak CNC
mill. Hands-on training emphasizes writing CNC programs for the mill, machine setup, setting and
adjusting tool offsets, and troubleshooting programs.
/($51,1*287&20(
This course covers the fundamentals of CNC setup, machine programming, and operation
techniques. The hands-on training emphasizes writing basic CNC programs for the mill, setting and
adjusting tool offsets, setting up a mill, and writing troubleshooting programs. CNC-operated
Bridgeport mills and EZ-Trak software are available for hands-on use. The successful completion
of this course should enable the participant to:
1. manually program and edit basic parts on the Bridgeport EZ-Trak CNC mill;
2. understand setup and operation techniques for CNC mills;
3. startup and grid, jog, program upload and download, set datum, set tool offsets, and run parts
on the Bridgeport EZ-Trak CNC mill;
4. set and change tool offsets to compensate for changes caused by cutter wear;
5. operate the Bridgeport EZ-Trak CNC mill control; and,
6. understand the Cartesian coordinate system and basic mathematics used for CNC
programming.
&2856(2%-(&7,9(
The participant should gain the knowledge and skills required to set up, operate and write basic
programs for the Bridgeport EZ-Trak CNC mill.
0$-25723,&6&29(5('
• Bridgeport EZ-Trak mill hardware • Coordinate systems • CNC mill operation
35(5(48,6,7(6
Training participants must be able to operate a milling machine.
&/$666,=(8
&2856('85$7,2140 hours
6(66,21'$7(6
October 6-10 November 17-21 December 15-19
January 5-9 April 19-23 July 19-23
February 9-13 May 17-21 August 23-27
March 22-26 June 14-18 September 13-17
16