Electrical Schematics (EST 100 ... - UAW-Chrysler.com

October 2003-September 2004
,1'8675,$/$8720$7,21
3527275$.0,// &2856(&17
352*5$00,1* 23(5$7,21
&2856('(6&5,37,21
This course covers the programming and operation fundamentals of the ProtoTrak CNC mill. Handson
training emphasizes writing CNC programs for the mill, machine setup, setting and adjusting tool
offsets, and troubleshooting programs.
/($51,1*287&20(
This course covers the fundamentals of CNC setup, machine programming, and operation
techniques. The hands-on training emphasizes writing basic CNC programs for the mill, setting and
adjusting tool offsets, setting up a mill, and writing troubleshooting programs. CNC-operated
ProtoTrak mills and ProtoTrak CNC mill software are available for hands-on use. The successful
completion of this course should enable the participant to:
1. manually program and edit basic parts on the ProtoTrak CNC Mill;
2. understand setup and operation techniques for CNC Mills;
3. start-up and grid, jog, program upload and download, set datum,
set tool offsets, and run parts on the ProtoTrak CNC Mill;
4. set and change tool offsets to compensate for changes caused by cutter wear;
5. operate the ProtoTrak CNC Mill Control; and,
6. understand the Cartesian coordinate system and basic mathematics used for CNC
programming.
&2856(2%-(&7,9(
The participant should gain the knowledge and skills required to set up, operate and write basic
programs for the ProtoTrak CNC mill.
0$-25723,&6&29(5('
• ProtoTrak CNC mill hardware • Coordinate systems • CNC mill operation
35(5(48,6,7(6
None
&/$666,=(8
&2856('85$7,2140 hours
6(66,21'$7(6
December 1-5
January 26-30 June 28-July 2
March 8- 12 September 27-October 1
17