Electrical Schematics (EST 100 ... - UAW-Chrysler.com

:(/',1*
48$/,),&$7,21&(57,),&$7,212)
October 2003-September 2004
&2856(:47
2 Hours
Upon arrival, training participants will be asked to designate a specific area of certification. Each
area of certification is its own specific course.
29(5$//&2856(2%-(&7,9(
The participant will demonstrate welding skills by completing welder qualification test(s) as
specified by the American Welding Society, American Society of Mechanical Engineers and/or the
Canadian Welding Bureau.
The specific topics covered in each certification are as follows:
(WQT 400) WELDING SKILLS FOR STRUCTURAL STEEL:The participant must pass a visual
inspection and a bend test or fillet break test.
(WQT 401) WELDING SKILLS FOR STRUCTURAL ALUMINUM: includes a review of welding
procedure specifications, variables that affect weld quality, and preparation of metal coupons for
destructive testing. The participant must pass a visual inspection and a bend test or fillet break test.
(WQT 402) WELDING SKILLS FOR STEEL PIPE (MIG): includes a review of welding codes and
qualifications, safe practices, material preparation and fit up of joint details. The participant must
pass a visual inspection and a bend test or fillet break test.
(WQT 403) WELDING SKILLS FOR STEEL PIPE (GMAW): includes a review of welding codes
and qualifications, safe practices and material preparation for welding of steel pipe needed to meet
industrial welding code requirements. The participant must pass a visual inspection and a bend test
or fillet break test.
(WQT 404) WELDING SKILLS FOR PIPE & TUBE (TIG)(GTAW): includes a review of welding
codes and qualifications, safe practices and material preparation for welding of steel pipe and tube
needed to meet industrial welding code requirements. The participant must pass a visual inspection
and a bend test or fillet break test.
(WQT 405) WELDING SKILLS FOR TOOL & DIE: includes a review of allowable repairs,
problem solving exercises and acceptance criteria per DaimlerChrysler Die Engineering processes
standards needed to repair tool and die materials. The participant must pass a visual inspection and
a cross section and etch test and passing a die penetrant test inspection.
Þ&217,18('211(;73$*(Þ
90