Electrical Schematics (EST 100 ... - UAW-Chrysler.com

:(/',1*
*$60(7$/$5&
0,*:(/',1*352&(66
October 2003-September 2004
&2856(:(7
2 Hours
&2856('(6&5,37,21
The participant should be able to set up and adjust gas metal arc welding equipment; select the
correct shielding gas, electrode, and filler metal; and weld fillet, groove, and surfacing welds using
the MIG welding process.
/($51,1*287&20(
Upon successful completion of this course, the participant should be able to:
1. set up and adjust gas metal arc welding equipment;
2. select the correct shielding gas, electrode and filler metal; and,
3. weld fillet, groove, and surfacing welds using the MIG welding process.
&2856(2%-(&7,9(
The participant should be able to successfully produce quality fillet, groove, and surfacing welds on
materials ranging from sheet metal to structural steel using the MIG welding process.
0$-25723,&6&29(5('
• Welding safety
• Equipment setup
• Fundamentals of gas metal arc welding and its applications
• Gas electrode wire and filler metal selection
35(5(48,6,7(6
To obtain the maximum benefit from this training, participants should possess a fundamental
knowledge of fusion welding. In addition, participants must meet ONE of the following: completion
of Welding Safety & Overview of Processes (WPT 100), equivalent welding safety training at a
community college, or certification from a welding safety course.
&/$666,=(6
&2856('85$7,2140 hours
6(66,21'$7(6
October 20-24 December 8-12
January 12-16 May 17-21 August 30-September 3
February 16-20 June 21-25 September 27-October 1
March 15-19 July 12-16
April 19-23 August 2-6
83