Electrical Schematics (EST 100 ... - UAW-Chrysler.com

:(/',1*
*$6781*67(1$5&
7,*:(/',1*352&(66
October 2003-September 2004
&2856(:97
2 Hours
&2856('(6&5,37,21
The participant should be able to safely use metal arc welding equipment, recognize process
variations, and carry out appropriate fillet and square groove welds on steel using the TIG process.
/($51,1*287&20(
Upon successful completion of this course, the participant should be able to:
1. set up and adjust gas metal arc welding equipment;
2. select the correct shielding gas, electrodes, and filler materials;
3. identify the process variations and applications; and,
4. weld fillet and square groove welds on carbon and stainless steel using the TIG welding
process.
&2856(2%-(&7,9(
The participant should be able to successfully produce quality fillet and square groove welds on
carbon and stainless steel using the TIG welding process.
0$-25723,&6&29(5('
• Welding safety
• Process variations
• Fundamentals of gas, metal gas, electrode,
and filler metal selection
35(5(48,6,7(6
To obtain the maximum benefit from this training, participants should possess a fundamental
knowledge of fusion welding. In addition, participants must meet ONE of the following: completion
of Welding Safety & Overview of Processes (WPT 100), equivalent welding safety training at a
community college, or certification from a welding safety course.
&/$666,=(6
&2856('85$7,2140 hours
6(66,21'$7(6
October 20-24 December 15-19
January 12-16 April 26-30 July 19-23
February 16-20 May 17-21 August 2-6
March 15-19 June 21-25 September 20-24
84