Electrical Schematics (EST 100 ... - UAW-Chrysler.com

,1'8675,$/0$,17(1$1&(
,1'8675,$/*($5%2;5(3$,5
October 2003-September 2004
&2856(*57
2 Hours
&2856('(6&5,37,21
The successful completion of this course should enable the participant to build gear boxes correctly,
troubleshoot failed gear boxes, select the proper gear box, install a speed reducer, replace seals and
bearings correctly, and set up a gear box using shims.
/($51,1*287&20(
Upon successful completion of this course, the participant should be able to:
1. analyze gear box failure;
2. rebuild gearboxes to correct tolerances;
3. select proper gearbox for application;
4. analyze and replace seals, bearings; and lubricants; and
5. axially align output with a drive shaft.
&2856(2%-(&7,9(
To provide the participant with the understanding and skill to select, troubleshoot, and install
gearboxes, and to rebuild and maintain gearboxes.
0$-25723,&6&29(5('
• Geometry review
• Application and characteristics of spur
• Gearbox selection
• Installation alignment
• Lubrication
• Thermal effects
• Bearing-seal performance
• Failure analysis
• Rebuild to specifications
• Helical, ring-pinion, herringbone, planetary,
worm, and bevel-miter gear trains
35(5(48,6,7(6None
&/$666,=(12
&2856('85$7,2140 hours
6(66,21'$7(6
December 1-5
February 23-27
May 3-7
September 13-17
61