ICAS-PAT manual for Design of process monitoring and ... - CAPEC

Figure 12: MoT model interface
3.5. Interdependency analysis (Step 5)
The following steps need to be taken in this phase of the design procedure (see Figure
13a):
3.5.1. Click on the command button, “Select a process point”, and select a process point
from the adjacent drop-down list (note that the process point selected in this step
must be identical to the process point selected in Step 4).
3.5.2. Selection of actuator candidates:
3.5.2.1. Click on the command button, “Select a critical process variable”, and select a
critical process variable (or select all) from the adjacent drop-down list.
3.5.2.2. Click on the command button, “List the actuator candidates”. This command
will list the actuator candidates for the selected critical process variable. Note
that this list provides the actuator candidates to the user based on data available
16