ICAS-PAT manual for Design of process monitoring and ... - CAPEC

Figure 19: Sensitivity verification
3.9. Final process monitoring & analysis system (Step 9)
The following steps need to be taken in this phase of the design procedure (see Figure
20):
3.9.1. Click on the command button, “Process monitoring & analysis system”. This
command will create a table containing the critical process points, critical process
variables, actuators, monitoring techniques and monitoring tools as shown in
Figure 20.
3.9.2. Repeat step 1-8 for each process point.
3.9.3. Draw flowsheet: follow the following steps to generate a process flowsheet with
designed PAT system.
• Click on the command button, “Select specifications”, and select the
specifications from the adjacent list box (see Figure 20) that you want to include
in the flowsheet.
• Click on the command button, “Draw flowsheet”, to draw the flowsheet, as
shown in Figure 21.
26