ICAS-PAT manual for Design of process monitoring and ... - CAPEC

2.3.4. Tick the box “Actuator candidates” (see Figure 3, left), if actuator candidates
also need to be retrieved.
2.3.5. Click on the command button, “Select process variables”, this action will retrieve
the process knowledge as shown in Figure 3 (see result selection). If the user is
only interested in retrieving process knowledge then there is no need to proceed
further, but if the user wants to retrieve the knowledge on measurement methods
and tools also then the next steps need to be followed as well.
2.3.6. Select process variables from the list box (adjacent to command button, “Select
process variables”) and also select the corresponding variable type from the list
box just below the list box containing the process variables.
2.3.7. Click on the command button, “Select monitoring techniques”, and select
monitoring techniques from the adjacent list box (note that, multiple selections are
possible).
2.3.8. Click on the command button, “Select monitoring tools”, and select monitoring
tools from the adjacent list box (note that, multiple selections are possible).
2.3.9. Click on the command button, “Select specifications”, and select specifications
from the adjacent list box (note that, multiple selections are possible).
2.3.10. Tick the box “Suppliers” (see Figure 3, bottom, left), if information on
equipment suppliers also needs to be retrieved.
2.3.11. Click on the command button, “Search specifications &/or suppliers of
monitoring tools”, to retrieve the process knowledge and knowledge on
measurement methods and tools.
2.3.12. Click on the command button, “Main interface”, to return to the main interface.
5