TECH - SPEC'S Technician's Pocket Guide - Hoshizaki America, Inc.

SETTING CHART FOR R-404A (F/H) MODELS
FACTORY DIP
SWITCH CODE 1=ON 0=OFF
SWITCH SETTINGS:
MODEL: 1 2 3 4 5 6 7 8 9 10
KM-150BA/W/A-E/W-E 0 1 0 1 0 0 0 0 0 0
KML-250MA 0 0 0 1 1 1 0 0 1 0
KM-280MA 1 0 0 1 1 1 0 0 0 0
KM-280MA-E 1 0 0 0 0 0 0 0 1 0
KML-250MW, KML-
350/450/600MA/W 0 0 0 1 1 1 0 0 0 1
KM-280/500MW-E 0 0 0 0 0 0 0 0 0 0
KM-280MWF, 0 0 0 1 1 1 0 0 0 0
KML-350MAF/MWF 0 0 0 1 1 1 0 0 0 1
KM-500MAF,
KM630MAF/MRF 0 0 0 0 1 1 0 0 1 0
KM-250B,
KM-500MWF/MRF,
KM-630MWF 0 0 0 0 1 1 0 0 0 0
KM-500MAF-E,
KM-630MAF-E/MWF-E 0 0 0 0 0 0 0 0 1 0
KML-600MRF 1 0 0 0 1 1 0 0 0 1
KM-1300S_F/SWF3,
KM-2000SWF3/SRF3 0 0 1 1 1 1 0 0 0 0
KM-1300SAF-E/SRF-E 0 0 1 1 0 0 0 0 1 0
KM-1300SWF-E 0 0 1 1 0 0 0 0 0 0
KM-1300MAF/MRF 0 0 1 0 1 1 0 0 0 0
KM-1300NRF 0 0 1 1 1 1 1 0 0 0
KM-900M_F/MRF3,
KM-1300MWF,
KM-1600MRF/MRF3 0 0 1 0 1 1 0 0 0 1
KM-1600SRF/SRF3 1 0 1 1 1 1 0 0 0 0
KM-1600SWF3 0 0 1 1 1 1 0 0 0 1
KM-1800SAH 0 0 1 1 1 1 0 0 1 0
KM-2400SRF3 0 0 1 0 0 0 0 0 0 1
Note: The above chart reflects the factory dip-switch settings
for models using R-404A refrigerant. Adjustments
may be made to switches 1, 2, 5, & 6 to improve the built-in
cleaning ability as per the DIP SWITCH SETTING GUIDE. If
you replace the control board, match the cleaning settings
with the original board. Switches 3, 4, 7, 8, 9, & 10 must
remain in the factory position.
20
12/01/02 12/20/03
2/20/03