VC1000 Focus Guide - ProLon

More documents

Recommendations

Info

VAV Controller www.prolon.net • Supply Temperature Deadband: This value indicates how much difference there must be between the supply temperature and the zone temperature before the damper switches from opening or closing. Units MIN MAX Default °C 0.5 10 1 °F 0.9 18 1.8 • Damper Proportional Band: Indicates the value of the demand that must be reached to open the damper to its maximum value. Units MIN MAX Default % 0 100 100 • Damper Differential: This is the amount by which the desired damper position must change before the damper will actually move. Units MIN MAX Default % 1 100 10 • Duct Heater Setpoint: The minimum value of the output designated as a duct heater required to enable use of the minimum heating damper position (pressure dependent) or the minimum flow heat setpoint (pressure independent). Units MIN MAX Default % 5 100 25 • Max Damper Opening: This value indicates the permanent maximum position of the damper. It is used to perform air balancing on the system through software. These values can only be accessed when the VAV Controller is set to pressure dependent. Units MIN MAX Default % 0 100 100 • Min Damper Opening: This value indicates the minimum position of the damper. It is used to maintain airflow in the zone. These values can only be accessed when the VAV Controller is set to pressure dependent. • Ventilation: Minimum damper opening value at all times. Units MIN MAX Default % 0 100 0 • Heating: Minimum damper opening value when one of the outputs is designated as a duct heater and whose value is greater than the duct heater setpoint. Units MIN MAX Default % 0 100 30 16 www.prolon.net info@prolon.net
VAV Controller www.prolon.net 2.1.4.2 Damper Setup • Damper Opening Direction: • Clockwise: The damper opens clockwise. • Counter Clockwise: The damper opens counter-clockwise. • Use Halomo: When this option is selected, damper positioning is calculated automatically using the Halomo motor. • Damper Opening Delay: The amount of time taken for the outboard floating type actuator to fully open, starting from a closed state. The actuator’s manufacturer specifies this value. When the Halomo motor is being used, damper positioning is done automatically, so this parameter is disabled. Units MIN MAX Default Seconds 15 300 95 17 www.prolon.net info@prolon.net
Page 1 and 2: Focus Guide VAV Controller Configur
Page 3 and 4: VAV Controller www.prolon.net Table
Page 5 and 6: VAV Controller www.prolon.net 1.2 I
Page 7 and 8: VAV Controller www.prolon.net • F
Page 9 and 10: VAV Controller www.prolon.net Figur
Page 11 and 12: VAV Controller www.prolon.net 2.1.2
Page 13 and 14: VAV Controller www.prolon.net • C
Page 15: VAV Controller www.prolon.net 2.1.4
Page 19 and 20: VAV Controller www.prolon.net • M
Page 23 and 24: VAV Controller www.prolon.net • P
Page 25 and 26: VAV Controller www.prolon.net • M
Page 29 and 30: VAV Controller www.prolon.net • C
Page 33 and 34: VAV Controller www.prolon.net 2.2 N
Page 35 and 36: VAV Controller www.prolon.net • U

VC1000 Focus Guide - ProLon

Create successful ePaper yourself

Delete template?

Save as template?